Coleman 10'x8' 9234 908 KENAI™ 10’x8’ User Manual To The 2fae0434 893a F224 992d F9ca9c8e4442

User Manual: Coleman 10'x8' to the manual

Open the PDF directly: View PDF PDF.
Page Count: 2

DownloadColeman 10'x8' 9234-908 - KENAI™ 10’x8’ User Manual  To The 2fae0434-893a-f224-992d-f9ca9c8e4442
Open PDF In BrowserView PDF
KENAI 10’x8’
™

Instructions apply to Part Number 9234-908
POLE ASSEMBLY PARTS

When You Are Ready
To Set Up Your Tent
– Select a level campsite clear of
rocks, branches and other hard
or sharp objects.
– Do not set up your tent under trees.
– For best results in windy conditions,
do not position the door of tent
into the wind.

1

Main Tent
Poles

Part No. 9234-3301

Rainfly
Pole

Part No. 9234-3311

Layout & Positioning
of Tent, Pole Assembly
– Layout and position tent with door
facing desired direction. (illus. 1)
– Unzip door.
– Stake down tent corners only, using
the rings at the end of the stake loops.
Keep the floor taut. (illus. 2)
– Assemble frame poles by
interlocking shock-corded poles.
This will make two long poles.
– Insert the poles diagonally into pole
sleeves. The center of the poles
should cross forming an “X” in the
middle of tent. (illus. 1)

Assembled
poles
inserted
through
pole
sleeves

Rainfly Part No. 9234-3321

2

Connect Frame to Tent
– Insert one end of the main tent pole
onto pin of pin & ring system, at the
tent corner. (illus. 3)
– Go to opposite end of pole and
gradually apply pressure to the pole
forming an arch until you are able to
insert the pin into the pole.
– Repeat for second pole. (illus. 4)

illus. 4
Tent frame set-up

illus. 1

illus. 3
illus. 2
Tent stake through ring

Insert pole end onto
pin & ring

Grommets for rainfly poles

3

Attach Tent to Frame
Using Frame Clips

illus. 5
Frame clips

– Attach frame clips along
the edges of tent to frame poles.
(illus. 5), (illus. 6)
– Make any adjustments to the tent
corner stakes that are needed.

illus. 6

Assembled tent without rainfly.

4

Attach Rainfly

Rainfly pole sleeves

– Assemble rainfly pole by
interlocking shock-corded pole.
– Insert rainfly poles into pole sleeves
located at the center edges of the
underside of rainfly. (illus. 6)
– Drape rainfly over tent frame, pole
side down. Rainfly poles should
cover door and rear window.
– Connect the four elastic loops with
“S” hooks, (found at the rainfly
corners) to the fabric loops
near frame clips. (illus. 9)
– Insert the tips of the rainfly poles
into the grommets.
– Secure rainfly with attachments
located on underside of fly. (illus. 10)
– Attach and stake out guylines.
(illus. 10)

Pole
Attachments

illus. 8
illus. 9
“S” hooks

Rainfly poles
Underside
of rainfly
attaches to
frame
poles
side guy
lines

illus. 10
Completed tent with rainfly.

Stake down
doormat

Things You Should Know

• Under certain conditions (cold weather, high humidity, etc.)

condensation will form on the inside surfaces of your tent. Condensation is
caused by water vapor from your breath, perspiration, or any wet clothing
inside your tent. It is NOT LEAKAGE through the tent fabric. It can be
minimized by removing wet clothing from your tent and by providing good
ventilation through the tent.

• Never store tent, even for a short period of time, without drying it

thoroughly and brushing off caked dirt. Do not pack stakes or poles inside
your tent. Use a separate storage bag.

• Do not leave your tent set-up for weeks at a time, be aware that

exposure to the ultraviolet rays of the sun can seriously damage material
and/or cause it to become discolored.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC. This tent meets the
flammability requirements of CPAI-84. The fabric will burn
if left in continuous contact with any flame source. The
application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.

• STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO
REMOVE STAKE.
TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.

•
• Seam sealer has not been provided with your tent. For additional protection

we recommend seam sealing your tent prior to camping. Seam sealer may be
purchased through your local retailer or at your local sporting goods store.

THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com

MADE IN CHINA
PRINTED IN CHINA

Rev. 9/05



Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
XMP Toolkit                     : 3.1-702
About                           : uuid:23391fc6-36ae-11da-aa55-000d93567d62
Producer                        : Acrobat Distiller 6.0.1 for Macintosh
Keywords                        : manuals
Create Date                     : 2005:10:06 16:14:09-05:00
Modify Date                     : 2008:05:30 08:04:09-05:00
Creator Tool                    : QuarkXPress: pictwpstops filter 1.0
Metadata Date                   : 2008:05:30 08:04:09-05:00
Document ID                     : uuid:23390ebd-36ae-11da-aa55-000d93567d62
Instance ID                     : uuid:5c037803-415b-418e-8a1e-cb8d4d7de355
Format                          : application/pdf
Creator                         : 9234-908 - KENAI™ 10’x8’
Title                           : 9234-908 - KENAI™ 10’x8’
Description                     : pdf
Subject                         : manuals
Page Count                      : 2
Author                          : 9234-908 - KENAI™ 10’x8’
EXIF Metadata provided by EXIF.tools

Navigation menu