Coleman 9160N101 Sundome 10x10 Tent User Manual To The D35e1506 2f16 4684 Bc4d F784fe2db7e0
User Manual: Coleman 9160N101 to the manual
Open the PDF directly: View PDF 
.
Page Count: 2
| Download | |
| Open PDF In Browser | View PDF |
™ SUNDOME 10’x10’ Instructions apply to Part Number 9160N101 When You Are Ready To Set Up Your Tent –Select a level campsite clear of rocks, branches and other hard or sharp objects. –Do not set up your tent under trees. –For best results in windy conditions, do not position the door of tent into the wind. –See owners manual for more tips. POLE ASSEMBLY PARTS Part No. 9160B102 Main Tent Poles Part No. 9160A103 Rainfly Poles Rainfly Part No. 9160N104 1 Layout & Positioning of Tent, Pole Assembly –Layout and position tent with door facing desired direction. (illus. 1) –Unzip door. –Stake down tent using the rings of the pin & ring system at the corners of the tent. Keep the floor taut. (illus. 2) –Assemble frame poles by interlocking shock-corded poles. This will make two long poles. –Insert the poles diagonally into pole sleeves.The center of the poles should cross forming an “X” in the middle of tent. (illus. 1) –Fasten frame tie on top of tent over both poles. (illus. 1), (illus. 3) Assembled poles inserted through pole sleeves 2 Connect Frame to Tent –Insert one end of main tent pole onto pin of pin & ring system at tent corner. (illus. 4) –Go to opposite end of pole and gradually apply pressure to the pole forming an arch until you are able to insert the pin into the pole. –Repeat for second pole. (illus. 5) illus. 3 Frame tie Frame tie illus. 5 Tent frame set-up illus.4 Insert pole end onto pin & ring illus. 1 illus. 2 Tent stake through ring 3 Attach Tent to Frame Using Frame Clips –Attach frame clips along the edges of tent to frame poles. (illus. 5), (illus. 6) –Make any adjustments to the tent corner stakes that are needed. illus. 5 Frame clips illus. 6 Assembled tent without rainfly. 4 Rainfly pocket Attach Rainfly –Assemble rainfly pole by interlocking shock-corded pole. –Insert rainfly pole into reinforced pockets located at the center edges of the underside of rainfly. (illus. 7), (illus. 8) –Attach underside of rainfly to the rainfly pole. (illus. 8) –Drape rainfly over tent frame, pole side down. Rainfly pole should point out over door and rear window. –Connect the four elastic loops with “S” hooks, (found at the rainfly corners) to the four rings located at the end of the stake loops at the corners of the tent. –Secure rainfly with attachments located on underside of fly. (illus. 9) –Stake out the tent with (2) side guylines. (illus. 9) Pole attachments illus. 7 Insert rainfly pole piece into pocket on underside of rainfly illus. 8 Rainfly pockets Underside of rainfly attaches to frame poles Side guyline “S” hooks attach to rings at the corners illus. 9 Completed tent with rainfly. Things You Should Know • Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent. • Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag. • Do not leave your tent set-up for weeks at a time, be aware that exposure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored. See owners manual for more tips. • WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of CPAI-84.The fabric will burn if left in continuous contact with any flame source.The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective. • STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE. TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE. • • Seam sealer has not been provided with your tent. We recommend seam sealing your tent prior to camping. Seam sealer may be purchased through your local retailer or at your local sporting goods store. PRINTED IN CHINA REV. 7/03 THE COLEMAN CO., INC. 3600 N. Hydraulic • Wichita, Kansas 67219 1-800-835-3278 • www.coleman.com MADE IN CHINA
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Create Date : 2004:01:16 20:33:03Z Modify Date : 2005:03:08 08:16:58-06:00 Subject : 9160N101 Sundome 10x10 Tent Keywords : Manuals Page Count : 2 Creation Date : 2004:01:16 20:33:03Z Mod Date : 2005:03:08 08:16:58-06:00 Producer : Acrobat Distiller 5.0.5 for Macintosh Author : 9160N101 Sundome 10x10 Tent Metadata Date : 2005:03:08 08:16:58-06:00 Creator : 9160N101 Sundome 10x10 Tent Title : 9160N101 Sundome 10x10 Tent Description : 9160N101 Sundome 10x10 TentEXIF Metadata provided by EXIF.tools