Coleman 9392 2251 9391 261 16’x16’ GEOSPORT™ SHADE User Manual To The A52c7a54 A406 4868 A467 4624cd2211a3

User Manual: Coleman 9392-2251 to the manual

Open the PDF directly: View PDF .
Page Count: 2

Pole & Hub Assembly

–Begin with the Center Hub and Canopy

Poles.

–Insert the end marked TOP into the

center hub and connect one pole at a

time to the hub. (illus1), (illus. 4)

–Add a canopy hub to the five open

ends of the center hub assembly.

(illus. 2), (illus. 4)

–Insert the clip end of Leg Connector

Poles into the Canopy Hub.

–Where the two open ends of the

Leg Connector Poles meet, insert them

into the two angled openings of the Leg

Hub. Repeat for 4 more sets. (illus. 3),

(illus. 4)

–Insert clip end of Leg Pole into

open end of Leg Hub. Disconnect the

shock-corded Leg Pole so that the

lower spiked pole is laying on the

ground. (illus. 4)

16’x16’ GEOSPORT™SHADE

1

2

3

4

When You Are Ready To Set Up Your

Shelter

–Select a level area clear of rocks,

branches and other hard or sharp objects.

–Do not assemble your shelter under trees.

–For easier set up, two or more people

are recommended.

ASSEMBLY PARTS

Instructions apply to Part Number 9391-261

Leg Poles (5)

Part No. 9392-6171

Leg Connector Poles (10)

Part No. 9392-6181

Leg Hub (5)

Part No. 9392-2271

Center Hub Part (1)

No. 9392-2251 Canopy Poles (5)

Part No. 9392-6161

Canopy Hub(5)

Part No. 9392-2261

Illus. 4

Partially assembled

frame with all hubs

in position

Illus. 3 Leg Hub

Partially assembled

frame locked into hub

Illus. 1

Poles inserted

into hub

Illus. 2

Canopy Hub

Center Hub

Canopy Pole

Center Hub

Canopy Hub

Leg Hub

Leg Pole

Canopy

Pole

Leg Connector Poles

Leg Connector Poles

Leg Pole

Leg Hub

5

PRINTED IN CHINA Rev. 8/06

Things You Should Know

• Never store shelter, even for a short period of time, without drying it

thoroughly and brushing off caked dirt. Do not pack stakes or poles inside

your shelter. Use separate storage bag.

• STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.

NEVER PULL ON THE SHELTER FABRIC OR SHELTER STAKE LOOP TO

REMOVE STAKE.

• SHELTER POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER

DURING STORAGE.

• Do not leave your shelter set-up for weeks at a time, be aware that expo-

sure to the ultraviolet rays of the sun can seriously damage material and/or

cause it to become discolored.

WARNING: Keep all flame and heat sources away from this tent fabric.

This shelter meets the flammability requirements of CPAI-84. The fabric will

burn if left in continuous contact with any flame source. The application of

any foreign substance to the shelter fabric may render the flame-resistant

properties ineffective.

THE COLEMAN CO., INC.

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN CHINA

Attach Shelter to

Frame

–Drape the canopy over the frame (illus. 5)

–Position each corner over a Leg Hub

–Fully extend each pole by

completing the interlocking of the

shock corded pole sections.

–Insert the brass hook into the hole

near the base of the pole (illus. 6, 8)

–From the inside of the shelter secure

the pole frame to the shelter with the

hook and loop closures.

–Adjust poles to pull the shelter taut

and stake down through the fabric

loops at the end of each pole

–Adjust hook straps to increase

tautness (illus. 7)

–Attach guy lines to fabric

guy loops at each corner

and stake out (illus. 7)

illus. 5 Fabric draped over

partially assembled frame

illus. 6

Insert Brass Hook

into hole near the

base of the pole

illus. 8

Completed shelter with guy lines

staked out

illus. 7

Stake through

Stake Loop

Use to adjust or

tighten canopy