Coleman 2000005512 Users Manual Tent Setup Instructions

2000005512 to the manual 10f2cdc9-df75-434b-a441-e9a9c4be09ae

: Coleman Coleman-2000005512-Users-Manual-365356 coleman-2000005512-users-manual-365356 coleman pdf

Open the PDF directly: View PDF .
Page Count: 2

STITCH LINE

TENT SETUP INSTRUCTIONS

MODEL 2000005512

Before you begin

Read all instructions before set up.

• Select a level site clear of rocks, branches, and other hard or

sharp objects, to install your tent.

WARNING: Keep clear of overhead power lines.

• Do not set up your tent under trees because of potential

lightning strikes or falling tree limbs in inclement weather.

• Secure with all stakes and guylines provided to prevent property

damage or personal injury.

• For best results in windy conditions, position narrow end of tent

into the wind.

• Do not drop tent.

• Do not bounce tent bag on its end to remove tent, as these

actions may damage the frame.

• THIS RECREATIONAL PRODUCT REQUIRES A MINIMUM OF TWO

PEOPLE TO ASSEMBLE.

• Under no circumstances should this product be used to cover

automobiles, marine products or similar items.

CAUTION: Avoid pinch points when opening and closing the

tent frame.

(continued on other side)

Extend the Tent Frame

Raise the Tent

• Stand the tent upright with the hub assembly at the top. (Fig. 1)

• Unfold the arms of the tent downward until they lay flat on the

ground. (Fig. 2)

• Unfold the arm joints located at each of the tent corners. The

tent will raise as the leg poles are extended. (Fig. 3 and 4)

• Extend each of the telescoping leg poles until they snap into

place. (Fig. 5 and 6)

1

2

Fig. 1

Fig. 5

Fig. 2

Fig. 3

3

Verify Connections

between Tent and

Frame Poles

Fig. 7

Fig. 6

• Verify the clips along the edges of the tent are properly attached to the

frame poles. (Fig. 7 and Fig. 8)

Fig. 4

Clip Pole

Fig. 8

STITCH LINE

4010007533 (20091204)

1. All stakes must be placed in the storage bag to prevent damage

to the fabric items placed in the carry case.

2. Make sure all components are clean and dry before placing in

carry case.

3. Store in a clean, dry area.

7

To Store

Things You Should Know:

• Under certain conditions (cold weather, high humidity, etc.)

condensation will form on the inside of your shelter. Condensation

is caused by water vapor from your breath, perspiration, or any wet

clothing inside the shelter. It is NOT LEAKAGE through the shelter fabric.

• Tree limbs, tree sap, bird droppings, or moisture steadily dripping

off tree limbs can cause damage to the shelter fabric and its coating

resulting in leaks or loss of flame-resistant properties.

• Never store tent, even for a short period of time, without drying it

thoroughly and brushing off caked dirt. Do not pack stakes inside your

tent. Use a separate storage bag.

• Stakes should be removed by pulling on the stake itself. NEVER

PULL ON THE TENT TO REMOVE STAKES AS THIS COULD RESULT IN

PROPERTY DAMAGE OR PERSONAL INJURY.

• Do not leave your tent set-up for weeks at a time. Be aware that

exposure to ultraviolet rays from the sun can seriously damage material

and/or cause it to become discolored.

• This product is not intended to be used during heavy rain, wind, hail,

snow or other inclement weather. Excess water build-up can cause

the frame system to be come unstable, and possibly collapse, causing

injury.

Disassembly

To take down the tent, follow the previous steps and illustrations

in the reverse order:

• Remove guylines and stakes. (Fig. 10 and 9)

• Lower the frame one leg pole at a time by pushing the lock

buttons and collapsing the telescoping leg poles. (Fig. 6)

• Fold the arm joints located at each of the tent corners. (Fig. 4)

• Collapse the tent by folding the arms upward until the tent

stands upright with the hub assembly at the top. (Fig. 2 and 1)

• Place the tent in the carry bag for storage.

TIP: After collapsing the tent, place it on its side, then roll it

multiple times with pressure to reduce its size. This will allow

the unit to slip into the carry bag.

6

The Coleman Company, Inc. • 3600 North Hydraulic • Wichita, Kansas 67219

1-800-835-3278 in the United States • www.coleman.com

MADE IN CHINA • PRINTED IN CHINA

© 2009 The Coleman Company, Inc. All rights reserved.

Coleman®, , and are registered trademarks of The Coleman Company, Inc.

This tent meets the flammability requirements of CPAI-84. The fabric

may burn if left in continuous contact with any flame source. The

application of any foreign substance to the tent fabric may render the

flame-resistant properties ineffective.

WARNING: Keep all flame and heat sources away

from this tent fabric.

• The tent should be taken down and placed in storage during windy

conditions to avoid damage to product or personal injury.

• DO NOT use gas or flame sources under or near this product.

Guyline

Stake

Fig. 10

Secure the Guylines

• Attach and stake out guylines. (Fig. 10)

• Adjust sliders to make guylines tight.

5

Stake the Tent

• Secure tent by driving stakes through the webbing loops sewn

to the tent base. (Fig. 9)

• Keep the floor taut.

4

Fig. 9

Tent

Stake

Webbing Loop