Communications Specialists PT-1 PT-1 Pet Transmitter User Manual Operational Description 2
Communications Specialists Inc PT-1 Pet Transmitter Operational Description 2
Users Manual
PT-1 PET TRANSMITTER
Introduction
The Communications Specialists Model PT-1 pet transmitter attaches to your pet's
collar so it can be found if lost. The transmitter is programmed to operate on one of 50
channels so multiple pets in a single household or neighborhood can operate at the same
time without interference to each other. The channel number of the transmitter is shown
on the sticker on the PT-1 case. It weighs less than 1/2 ounce including the battery which
allows it to be used with the smallest of pets. The battery will power the PT-1 for
approximately 6 weeks.
Installation
Remove the collar from around your pet's neck and punch a small hole in it with a
sharp nail or icepick. Unscrew the small nut holding on the antenna from the threaded
shaft on the back of the PT-1. Push the threaded shaft through the hole previously
punched in the collar. Reinstall the antenna on the threaded shaft and secure it with the
removed nut. Tighten down the nut so the PT-1 and antenna do not twist and are securely
attached to the collar. The PT-1 should be on the outside of the collar and the antenna
should be laying parallel against it.
Battery
The battery is a CR2032 Lithium cell that is available from us in a 12 pack
conveniently labeled for monthly battery changes. It may also be found at drug stores or
markets that sell photo or hearing aid batteries. To change the battery, pop off the front
cover on the PT-1 using your fingernail and remove the battery by grasping the finger tab
that is laying down against the + side of it. Pull out the battery and dispose of it properly.
Remove the current month's battery from the 12 pack by pushing it through the back of
the package. This way you will always know in which month you replaced it. Install the
new battery by holding the finger tab and gently sliding it into the battery compartment.
Pop the back cover on and you are done for another 6 weeks.
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications to this device will void the user's authority to
operate the equipment.
Warranty
The PT-1 is warranted to be free of defects in materials and workmanship for a
period of one (1) year from the date of purchase. Just return the unit to the factory and we
will repair or replace it at no charge.