Compupal Group CSPBTHOL16 Portable Bluetooth Speaker User Manual NS CSPBTHOL16 BK BL G R 16 0540 QSG V2 EN

Compupal Group Corporation Portable Bluetooth Speaker NS CSPBTHOL16 BK BL G R 16 0540 QSG V2 EN

Users Manual

SAFETY
INFORMATION
Use the speaker in normal temperatures.
Do not use the speaker under the water.
Do not throw the speaker.
Do not cover or insert anything into the
holes in the speaker.
Do not put the speaker close to any heat
source.
Contact your retailer if the charging cable
does not connect to your speaker.
Do not disassemble, repair, or modify the
speaker.
Do not charge the speaker using more
than 5V.
High volumes may damage your hearing.
Use the speaker at a lower volume.
Disassembling the speaker voids its
warranty.
PACKAGE
CONTENTS
• Bluetooth speaker
USB charging cable
Quick Setup Guide
Before using your new product, please read
these instructions to prevent any damage.
FEATURES
Wirelessly stream from any Bluetooth device
Rechargeable battery lasts up to 8 hours.
Speakerphone for hands-free calling
Top and front views Back view
CHARGING YOUR SPEAKER
The speaker beeps when the battery is low.
Connect the micro USB cable from your speaker’s micro USB port to a USB port (such as a
computer or wall charger). The charging LED lights red while charging, then turns o
when the battery is fully charged.
CONNECTING AN
AUDIO DEVICE
Bluetooth
1 Press and hold (power) to turn on
your speaker. The Bluetooth LED blinks
blue slowly and your speaker
automatically enters pairing mode.
2 Make sure that your Bluetooth device is
within 33 ft. (10 m) of your speaker.
3 Turn on your Bluetooth device, turn on
Bluetooth, then enter pairing mode.
For more information, see the
documentation that came with your
Bluetooth device.
4 On your Bluetooth device, select
NS-CSPBTHOL16. Your speaker pairs
with your Bluetooth device and the
Bluetooth LED lights solid blue.
5 To disconnect, un-pair your Bluetooth
device from your speaker.
Audio cable
Connect a 3.5 mm audio cable (not
included) from your speaker’s AUX IN
jack to your audio device’s
headphone/audio out jack.
QUICK SETUP GUIDE
Stereo
Speaker
NS-CSPBTHOL16
LED indicator Call button
AUX In jack
USB port
Reset
Power button
Volume +/- buttons
Flat size (W×H): 210 × 101 mm.
Final folded size: 42 × 101 mm.
NS-CSPBTHOL16-BK-BL-G-R_16-0540_QSG_V2_EN.pdf 1 7/8/2016 11:45:16 AMNS-CSPBTHOL16-BK-BL-G-R_16-0540_QSG_V2_EN.pdf 1 7/8/2016 11:45:16 AM
V2
FINAL
FOR PRINT
V2 ENGLISH 16-0540
USING YOUR
SPEAKER
Listening to audio
1 Play audio on your connected
device.
2 Press + or - to adjust your speaker’s
volume.
Note: Make sure that your connected
device’s volume is set to at least 50%.
3 Use the controls on your connected
device to control playback.
TAKING A PHONE
CALL
The following functions are available
when paired to a phone with
Bluetooth:
Reject an incoming call: Press and
hold (call).
Answer an incoming call: Press
(call).
Switch audio between your
speaker and phone: Press and hold
(call).
End current call: Press (call).
Redial the last dialed number: Press
(call) twice.
LED INDICATORS:
TROUBLESHOOTING
Unable to pair.
Turn your speaker o, then back on.
If a passcode is needed, enter 0000.
Move your speaker and Bluetooth device
closer together.
Static or breaks while playing audio.
Move your speaker and Bluetooth device
closer together.
LED
Blinks blue
slowly
Lights solid blue
Solid blue
Lights red
FUNCTION
Bluetooth pairing mode
Paired to a Bluetooth
device
Connected to an
AUX device
Speaker is charging
(charging complete
when LED turns o)
Use a paper clip to press reset.
Make sure that the audio cable is
connected securely.
Try a dierent audio cable.
No sound.
Turn up the volume on both your speaker
and connected device.
Make sure that your Bluetooth device is
paired to your speaker.
Unplug the audio cable (if connecting
with Bluetooth).
No power.
Make sure that your speaker is fully
charged.
Unable to operate.
Use a paper clip to press reset.
LEGAL NOTICES
lf at any time in the future you should need to
dispose of this product, note that waste
electrical products should not be disposed of
with household waste. Recycle where
facilities exist. Check with your Local
Authority or retailer for recycling advice. (Waste Electrical
and Electronic Equipment Directive)
Owing to continuous improvement, no prior notice will be
given regarding changes on features and specications.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
FCC Caution
Changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate this equipment.
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, maybe cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment o and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit dierent
form that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
RSS-Gen & RSS-247 statement:
This device complies with Industry Canada licence-exempt RSS
standard(s).
Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept
any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur
de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre
le fonctionnement.
RSS-102 Statement:
This equipment complies with Industry Canada radiation
exposure limits set forth for an uncontrolled environment.
Cet équipement est conforme à l'exposition aux
rayonnements Industry Canada limites établies pour un
environnement non contrôlé.
ONEYEAR LIMITED
WARRANTY
Visit www.insigniaproducts.com for details.
CONTACT INSIGNIA:
For customer service, call
1-877-467-4289 (U.S. and Canada) or
01-800-926-3000 (Mexico)
www.insigniaproducts.com
INSIGNIA is a trademark of Best Buy and its aliated
companies
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richeld, MN 55423 U.S.A.
©2016 Best Buy. All rights reserved.
Made in China
NS-CSPBTHOL16-BK-BL-G-R_16-0540_QSG_V2_EN.pdf 2 7/8/2016 11:45:17 AMNS-CSPBTHOL16-BK-BL-G-R_16-0540_QSG_V2_EN.pdf 2 7/8/2016 11:45:17 AM

Navigation menu