ContextMedia Health PPLAYIT Media Player User Manual

ContextMedia Health LLC Media Player Users Manual

Users Manual

Ethernet CableHDMI CableRS232 Cable
FCC StatementThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with theinstructions, may cause harmfu interferencel to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which canbe determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:Reorient or relocate the receiving antennaIncrease the separation between the equipment and receiverConnect the equipment into an outlet on a circuit different from that to which the receiver is connectedConsult the dealer or an experienced radio/TV technician for helpTo assure continued compliance, any changes or modifications not expressly approved by the partyResponsible for compliance could void the user’s authority to operate this equipment( i.e. use only shielded interface cables when connecting to computer or peripheral devices) This device is designed to meet the requirements for exposure to radio waves established by the Federal FCC ID: 2AI6X-PPLAYITIC: 21722-PPLAYITCommunications Commission (USA) and Canada. This Transmitter must be installed to provide a separation distance of at least 20 cm from all persons. This device complies with Industry Canada licence-exempt RSS standard(s).Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement." The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmfulinterference to co-channel mobile satellite systems.High-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices.” Le dispositif pour l’opération dans la bande 5150-5 250 MHz est uniquement pour usage à l’intérieur réduire le risque de brouillage canal commun de systèmes mobiles par satellite.Haute puissance radars préjudiciable au sont désignés comme utilisateurs principaux (c'est-à-dire les utilisateurs de priorité) des bandes 5250-5350 MHZ et radars pourraient causer des interférences et/ou endommager les 5650-5850 MHz et que ces dispositifs LAN-EL.Only approved detachable antennas can be usedThe devices with detachable antenna(s), the maximum antenna gain permitted for devices in the band 5725-5850 MHz shall be such that the equipment still complies with the e.i.r.p. limits specified for point-to-point and non-point-to-point operation as appropriate; The worst-case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask requirement set forth in RSS-247 Section 6.2.2(3) shall be clearly indicated, that is: (not applicable).

Navigation menu