Continental Automotive 5WK48028 Car Security Remote Control User Manual Instruction Manual

Download:
Mirror Download [FCC.gov]
Document ID	76621
Application ID	bICGAyi+QFW3EOj/+o1P3Q==
Document Description	Instruction Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	12.11kB (151394 bits)
Date Submitted	1999-12-16 00:00:00
Date Available	2000-02-10 00:00:00
Creation Date	1999-12-15 15:47:46
Producing Software	Acrobat 3.0 Scan Plug-in
Document Lastmod	1999-12-15 15:48:09
Document Title	Instruction Manual
Document Creator	Acrobat 3.0 Scan Plug-in

SIEMENS AT BE A5 T12
Operating Manual/Functional Description
for
SIEMENS -
VENUS Radio Frequency System
Chip Card 315 MHz
SIEMENS AT BE AS T12
Functional Description - VENUS Radio Freguency System
The VENUS radio frequency system is an optional unit which enables
convenient vehicle operation. All the driver needs to do in order to use the
vehicle is simply to carry a chip card along with him. The vehicle activates the
chip card by induction
The card can be excited by pressing a button, or by inductive activation to
emit a code to the vehicle. if this code is assessed as "valid", the vehicle is
locked or unlocked.
If the engine of an unlocked vehicle is to be started the chip card must be
located inside the vehicle. If the code emitted by the chip card is valid the
engine can be started. -
To open and close the vehicle by remote control, and to start the engine, the
chip card emits an FSK signal (frequency §hift Keying) up to three times for
20 ms to 60 ms, on a mid-frequency of approx. 315 MHz. The frequency
deviation ranges from 20l5Hz to lOOkHz. The signal is modulated with ikHz.
The system uses the Manchester code.
List of components
MLFB Number Component
swr<4 8028
FCC ID: KRSSWK48028
This device complies with pan 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
SIEMENS AT BE AS m
Description of the test setup for the VENUS radio freguency system
The test setup comprises the following pans:
- Card in normal mode
- Chip card in test mode .,Continuous transmission"
Start-up
When operating the chip card in normal mode, the chip card activates the two
status LEDs (green) on actuation of the button, and emits a radio frequency
telegram first. Then the LED on the chip card goes on briefly._
When operating the chip card in continous mode, the chip card can be
activated by pressing the button continousely, until the LED goes out. Then,
the button must be released and the chip card begins to emit permanently in
the continuous mode
The chip card only stops the transmission process after the button is pressed
once again There is no LED signal for switching off.
To terminate the activated test mode, the user may also remove the batteries.
The test mode is retained even if the batteries have been removed; however,
in this case, it is not active
This procedure does not correspond to the standard mode of operation
of the chip card ll!
This procedure was intended to simplify radiation measurement. In normal
mode, the chip card only emit at intervals of max. 0.06 seconds.
Should you have any queries or problems, please do not hesitate to contact:
SIEMENS AG
AT BE AS CS 6
Mr. Vorlauter
WernerwerkstraBe 2
D-93049 Regensburg
Phone: +49/941/202—3556
Fax: +49/941/202—3591

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Modify Date                     : 1999:12:15 15:48:09
Creator                         : Acrobat 3.0 Scan Plug-in
Producer                        : Acrobat 3.0 Scan Plug-in
Create Date                     : 1999:12:15 15:47:46
Page Count                      : 3

EXIF Metadata provided by EXIF.tools