Controlled Entry Distributors 318LIPWV 318LIPWxV & 318DOPWxV Models User Manual 318LLT
Controlled Entry Distributors, Inc. 318LIPWxV & 318DOPWxV Models 318LLT
Exhibit 8
TRANSMITTER STINGRAY 318LIPWxV ua an of facility code which allows up to 16 facility codes. Each transmitter is individually numbered, can be used with any receiver capable of receiving a 26 bit input and can operate any type of access control system equipped with the same protocol. The 23A alkaline battery has a life of about 12-18 months. The product fully complies Part 15 of FCC Regulations. 1B - Technical specifications Transmitter Solutions Thank you for choosing a Transmitter Solutions product . Please read this manual carefully before using the product. Made in Italy. Copyright © 2006 by Transmitter Solutions CONTENTS 1 - TRANSMITTER INTRODUCTION 1A - General information 1B - Technical specifications 1C - Main features 1D -Types Number of keys: Supply : Battery life: Current consumption : Operating frequency : Code combinations : Facility codes Modulation : Rated e.r.p. : Range in free space: Operating temperature: Overall dimensions: Weight: 1/2 1 Alkaline Battery 12V type 23A 12 - 18 months 25 mA 318 MHz 65,536 16 AM / ASK 50 - 100 mW 60 - 120 yd -20 ÷ +55 °C 3.26 x 1.88 x 0.62 in 20 gr. 1C - Main features Red LED Pushbutton blue Push-button blue 2 - NUMBERING 3 - PROGRAMMING Enclosure light-grey 4 - OPERATION 5 - BATTERY ACCESS 6 - TROUBLESHOOTING 1A - General information Transmitter Solutions - Stingray 318LIPWxV is a visor transmitter operating at 318 MHz in ASK modulation. It has been designed for use with programmable telephone entry, security, and access control systems operating with a 318 MHz frequency receiver. The code sent by the transmitter includes a 16 bit security code which allows up to 65,536 code combinations and 4 bits 318LIPW1V Key holder ring 318LIPW2V Battery door 6 - TROUBLESHOOTING 1D - Types STINGRAY 318LIPW1V : 1 button transmitter STINGRAY 318LIPW2V : 2 button transmitter 2 - NUMBERING Each transmitter is manufactured and sold with a different factory set sequence number and facility code. FAULT SOLUTION The system does not receiver the transmitter signal. The transmitter LED will not light Replace the transmitter batteries The system does not receiver the transmitter signal. The transmitter LED is ON Check to verify the transmitter is programmed into your system The operating range is reduced Replace the transmitter batteries 3 - PROGRAMMING The transmitter facility code and sequence number must be programmed into your system memory. Your own installer or reseller will provide you the necessary instructions for your system. 4 - OPERATION a. Firmly depress either button until the small red LED illuminates. b. After the LED has illuminated, release the button. If the device you are attempting to activate does not respond, repeat steps a. and b. or consult section 6 (Troubleshooting) of this manual. 5 - BATTERY ACCESS FCC ID : SU7318LIPWV This device complies with Part. 15 of the FCC Rules Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept interference received, including interference that may cause undesired operation. Notice To access the battery slide out the battery door Place the 23A alkaline battery between the 2 contacts. Respect the right polarity as indicated on the bottom of the box. NOTE: Please dispose of the batteries properly according to local laws and regulations. Test proper battery installation by verifying that the red LED illuminates when either button is pushed. Battery + 23A _ Any changes or modification to Transmitter Solutions equipment not expressly approved by Transmitter Solutions could void the manufacturer’s warranty and the user’s authority to operate this product. WARRANTY The warranty period of Transmitter Solutions 318 transmitters is 24 months, beginning from the manufacturing date of the transmitter. During this period, if the product does operate correctly, due to a defective component, the product will be repaired or replaced at the sole discretion of Transmitter Solutions. The warranty does not extend to the transmitter case which can be damaged by conditions outside the control of Transmitter Solutions or to battery life. Polarity OPEN TRANSMITTER SOLUTIONS 2505 Chandler Avenue, Suite, 1 Las Vegas, NV 89120 (866) 975-0101 - (866) 975-0404 Fax sales@transmittersolutions.com IS-T11318LCCUK Rev. 0 del 27.06.06 TRANSMITTER STINGRAY 318DOPWxV ua an 6 bits of facility code, which allows up to 64 facility codes. Each transmitter is individually numbered, can be used with any receiver capable of receiving a 26 bit input and can operate any type of access control system equipped with the same protocol. The 23A alkaline battery has a life of about 12-18 months. The product fully complies Part 15 of FCC Regulations. 1B - Technical specifications Transmitter Solutions Thank you for choosing a Transmitter Solutions product . Please read this manual carefully before using the product. Made in Italy. Copyright © 2006 by Transmitter Solutions CONTENTS 1 - TRANSMITTER INTRODUCTION 1A - General information 1B - Technical specifications 1C - Main features 1D -Types Number of keys: Supply : Battery life: Current consumption : Operating frequency : Code combinations : Facility codes Modulation : Rated e.r.p. : Range in free space: Operating temperature: Overall dimensions: Weight: 1/2 1 Alkaline Battery 12V type 23A 12 - 18 months 20 mA 318 MHz 16,384 64 AM / ASK 50 - 100 mW 60 - 120 yd -20 ÷ +55 °C 3.26 x 1.88 x 0.62 in 20 gr. 1C - Main features Red LED Push-button red 2 - NUMBERING 3 - PROGRAMMING Push-button red Enclosure light grey 4 - OPERATION 5 - BATTERY ACCESS 6 - TROUBLESHOOTING 1A - General information Transmitter Solutions - Stingray 318DOPWxV is a visor transmitter operating at 318 MHz in ASK modulation. It has been designed for use with programmable telephone entry, security, and access control systems operating with a 318 MHz frequency receiver. The protocol is MicroCLIK® compatible and the code sent by the transmitter includes a 14 bit security code which allows up to 16384 code combinations and 318DOPW1V Key holder ring 318DOPW2V Battery door 6 - TROUBLESHOOTING 1D - Types STINGRAY 318DOPW1V : 1 button transmitter STINGRAY 318DOPW2V : 2 button transmitter 2 - NUMBERING Each transmitter is manufactured and sold with a different factory set sequence number and facility code. FAULT SOLUTION The system does not receiver the transmitter signal. The transmitter LED will not light Replace the transmitter batteries The system does not receiver the transmitter signal. The transmitter LED is ON Check to verify the transmitter is programmed into your system The operating range is reduced Replace the transmitter batteries 3 - PROGRAMMING The transmitter facility code and sequence number must be programmed into your system memory. Your own installer or reseller will provide you the necessary instructions for your system. 4 - OPERATION a. Firmly depress either button until the small red LED illuminates. b. After the LED has illuminated, release the button. If the device you are attempting to activate does not respond, repeat steps a. and b. or consult section 6 (Troubleshooting) of this manual. 5 - BATTERY ACCESS FCC ID : SU7318LIPWV This device complies with Part. 15 of the FCC Rules Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept interference received, including interference that may cause undesired operation. Notice To access the battery slide out the battery door Place the 23A alkaline battery between the 2 contacts. Respect the right polarity as indicated on the bottom of the box. NOTE: Please dispose of the batteries properly according to local laws and regulations. Test proper battery installation by verifying that the red LED illuminates when either button is pushed. Battery + 23A _ Any changes or modification to Transmitter Solutions equipment not expressly approved by Transmitter Solutions could void the manufacturer’s warranty and the user’s authority to operate this product. WARRANTY The warranty period of Transmitter Solutions 318 transmitters is 24 months, beginning from the manufacturing date of the transmitter. During this period, if the product does operate correctly, due to a defective component, the product will be repaired or replaced at the sole discretion of Transmitter Solutions. The warranty does not extend to the transmitter case which can be damaged by conditions outside the control of Transmitter Solutions or to battery life. Polarity OPEN TRANSMITTER SOLUTIONS 2505 Chandler Avenue, Suite, 1 Las Vegas, NV 89120 (866) 975-0101 - (866) 975-0404 Fax sales@transmittersolutions.com IS-T11318DCCUK Rev. 0 del 27.06.06
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : No Encryption : Standard V2.3 (128-bit) User Access : Print, Print high-res XMP Toolkit : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:14:39 Producer : Acrobat Distiller 5.0 (Windows) Create Date : 2006:06:28 13:49:14Z Modify Date : 2007:05:05 13:39:30-06:00 Metadata Date : 2007:05:05 13:39:30-06:00 Creator Tool : PScript5.dll Version 5.2.2 Format : application/pdf Creator : product_mgr Title : 318LLT.cdr Document ID : uuid:3bf8d232-c753-4e95-95c6-e7a86daeeae0 Instance ID : uuid:2c0cfe64-dc11-42d3-928f-37bae68c16a0 Page Count : 4 Author : product_mgrEXIF Metadata provided by EXIF.tools