Cora Tine Teoranta T A Kelsius K115 Wireless Sensor Module User Manual Manual

Download:
Mirror Download [FCC.gov]
Document ID	1621442
Application ID	94vecrGldlGpZ21Iu6HYPg==
Document Description	Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	75.87kB (948317 bits)
Date Submitted	2012-01-16 00:00:00
Date Available	2012-01-16 00:00:00
Creation Date	2012-01-13 17:28:49
Producing Software	GPL Ghostscript 8.15
Document Lastmod	2012-01-13 17:28:49
Document Title	Microsoft Word - K115 Amplified Module Manual v1-2.doc
Document Creator	PScript5.dll Version 5.2.2
Document Author:	Dominic

Product Manual
Wireless Sensor Module K115
FCC ID: Z4GK115
Antenna
Sensors and Op Amp
EEPROM memory
Linx Technologies
Part Number
ANT-916-CW-QW
with part 15 compliant
RP-SMA connector
Nordic 10mW
Transceiver
TI CC1190 Amplifier
Battery Connections
Linear voltage
regulator
12 VDC input
Instruction for installation
Note the enclosure into which this module is installed must display a Label clearly visible to the user
without magnification stating “Contains FCC ID: Z4GK115”
This module is to be installed only in the end products of Cora Tine Teoranta t/a Kelsius
Analogue Sensors (2):
Thermistor:
R@25 deg C = 10KOhms +/- 1%
B = 3977 +/- 1%
Analogue Sensors (1):
Power supply is monitored by 1M to 47K resistive
divider.
Digital Sensor:
Normally Open contact
3.3VDC 25mA
Digital Sensor:
Sensirion SHT11 Temperature and Relative
Humidity sensor
Digital Outputs:
GPIO 3 Green LED indicates connectivity
GPIO 1 Alarm Output
Back Up Battery:
3.6V 1AHr. AA Nickel Cadmium battery pack (2)
Power Supply:
12VDC >500mA UL approved mains adaptor.
Radio Frequency Band:
902 to 928MHz
Line of sight Radio Range:
1000m
Modulation Type:
FHSS
Power Output:
200mW
Reprogrammability:
Fully Reprogrammable over RF
Antenna:
Linx Technologies.
Part Number ANT-916-CW-QW
With part 15 compliant RP-SMA connector
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
WARNING! This module is to be installed only in Cora Tine Teoranta t/a Kelsius
end products by Cora Tine Teoranta t/a Kelsius personnel, and shall not be
offered to 3rd party OEM integrators or the general public.
The RF Module is labeled with its own FCC ID Number. If the FCC ID is not visible when the
module is installed inside another device, then the outside of the device into which the module is
installed must also display a label referring to the enclosed module. This exterior label can use
wording such as the following:
Contains Transmitter Module FCC ID: Z4GK115
or
Contains FCC ID: Z4GK115
To comply with FCC RF radiation exposure limits for general population, the antenna(s)
used for this transmitter must be installed such that a minimum separation distance of
20cm is maintained between the radiator (antenna) and all persons at all times and must
not be collocated or operating in conjunction with any other antenna or transmitter.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Page Count                      : 3
Producer                        : GPL Ghostscript 8.15
Create Date                     : 2012:01:13 17:28:49
Modify Date                     : 2012:01:13 17:28:49
Title                           : Microsoft Word - K115 Amplified Module Manual v1-2.doc
Creator                         : PScript5.dll Version 5.2.2
Author                          : Dominic

EXIF Metadata provided by EXIF.tools