Coretronic WU5205C 802.11b/g/n Mini Wireless LAN USB2.0 Adapter User Manual WU5205C manual 1105 v1
Coretronic Corp. 802.11b/g/n Mini Wireless LAN USB2.0 Adapter WU5205C manual 1105 v1
User Manual
2
802.11 b/g/n Mini Wireless LAN USB2.0 Adapter
WU5205C
The wireless USB adapter should be plugged to DLP projector to enable the
RF transmitting and receiving function automatically. User can select the video
signal transmission through wireless from OSD menu of DLP projector. The
detail operation procedure, please refer to DLP projector user manual.
PRODUCT SPECIFICATION
PRODUCT 802.11b/g/n Mini Wireless LAN USB2.0 Adapter
MODEL NO. WU5205C
FCC ID
IC ID
SUZ-WU5205C
5923A-WU5205C
POWER SUPPLY DC 5V±10% from Projector
MODULATION TYPE CCK, DQPSK, DBPSK for DSSS
64QAM, 16QAM, QPSK, BPSK for OFDM
MODULATION
TECHNOLOGY DSSS, OFDM
TRANSFER RATE Complies with IEEE 802.11n draft 3.0 and IEEE 802.11 b/g
standards.
1T1R Mode with 150Mbps PHY Rate for both.
OPRTAING
FREQUENCY 2412MHz ~ 2462MHz
NUMBER OF CHANNEL
11 for 802.11b, 802.11g, 802.11n (20MHz)
7 for 802.11n (40MHz)
I/O PORTS NA
ASSOCIATED DEVICES
NA
2
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
IEEE 802.11b or 802.11g operation of this product in the U.S.A. is firmware-limited to channels
1 through 11.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
Industry Canada Statement
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the
following two conditions:
1) this device may not cause interference and
2) this device must accept any interference, including interference that may cause undesired
operation of the device
IMPORTANT NOTE:
IC Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
NCC 警語
警語警語
警語
經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大
功率或變更原設計之特性及功能。
低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，
並改善至無干擾時方得繼續使用。前項合法通信，指依電信法規定作業之無線電通信。低功率射
頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾
。