Corsair Memory SP90B0001 Bluetooth Speaker User Manual Manual

Download:
Mirror Download [FCC.gov]
Document ID	2091979
Application ID	n8si0VZE/z5k4M3T0Ida1Q==
Document Description	Manual.pdf
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	80.2kB (1002560 bits)
Date Submitted	2013-10-17 00:00:00
Date Available	2013-10-17 00:00:00
Creation Date	2013-09-20 17:15:35
Producing Software	Adobe Acrobat 7.0 Image Conversion Plug-in
Document Lastmod	2013-09-20 17:15:48
Document Title	Manual.pdf
Document Creator	Adobe Acrobat 7.0

Let’s Go!
Quick Start Guide
(SD srmple audio”
You'll love the way your music sounds 3"
O 2013 Simple Audio. Ltd. All rhht: med.
Simple Audio. the Simple Audio logo. and Slrrple Audio Go I.
trxbmuksolSlmple Audio In the Unllxl State- and odrer
ourntnoe. You'll love the way your mic count is a service
mark of Simple Audlo. Ltd.
Printed in china
Wohopeyouhlvonmuchhnuolng
younowanploAudoGov-epooknr
“waded-damn.
Now would be a good time to charge
your new speaker. You can still connect
to it and play your favorite music. but
the battery will be happiest if you give it
a full charge before you are on the go.
Connect the USB cable to the AC
adapter or to a powered USB port. and
then to the connector on the back of the
speaker:
Connoctevlthyowmmlc
Your new Go speaker connects to any
Bluetooth-enabled device that supports
audio (it's called A2DP). Put your
speaker in pairing mode by pressing
and holding the 0 button for 3 seconds.
You'll hear a tone that tells you Go is
ready to pair.
Go to the Bluetooth menu on your
device and select Simple Audio Go.
After a few seconds, another tone tells
you you're connected.
Safety lnfonnation
' When connecting or disconnecting the charger
that came with your Simple Audio product to an
AC power outlet. hold the charger by its sidl.
Keep your fingers away from the metal parts.
0 Always use the charger that came with your
product. llsing odier chargers may damage the
electronics and/or rechargeable battery.
0 Never force any connector into the jacks. Make
sure the connector mobiles the jack and you
have correctly oriented the connector. If more
than reasonable force is needed. the connections
may not match and you may damage your
device.
0 Avoid using the product in wet locations.
Charging or using your Simple Audio product in
or near water or wet locations increases the
chance of shock or iniury. and can damage the
electronics.
0 Do not attempt to open or disassemble your
Simple Audio product. if you do. you run the risk
of electric shock andlor Inlury. and you will void
the limited warranty. There are no
user-serviceable parts Inside.
FOO Declaration of Conformity
This device complies with Part 15 of the FCC
Rules. Operation is subiect to the following two
conditions: (1) this device may not cause harmful
Interference. and (2) this device must accept any
Interference received. Including Interference they
cause undesired operation.
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation
is subject to the following two conditions: (1) this
device may not cause
Itadlo and 1blevlslon Interference
This equlpmerlt has been tested and found to
comply with the limits for a Class B digital device.
pursuant to part 15 of the FCC Rules.Theee limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates uses and can
radiate radio frequency energy and. it not installed
and used in accordance with the instnrctions, may
cause hamrlul interference to radio communica-
tions. However, there is no guarantee interference
will not occur in a particular installation.
if this equipment does cause hannlul interference
in radio or television reception. which can be
determined by turning the equipment off and on, the
user is encouraged to by In conect the interference
by one or more of the tolan measures:
0 Reorlent or relocate the receMng antenna.
0 Increase the separation between the equipment
and receiver.
0 Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
0 Consult the dealer or an experienced radio/TV
technician for help.
Warning: Changes or modifications to this
unit not expressly approved by the party
responsible for compliance could void the user‘
5 authority to operate the equipment.
Exposure to Radio Frequency Energy
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
Under Industry Canada regulations. this radio
transmitter may only operate
using an antenna of a type and maximum (or
lesser) gain approved for the transmitter
interference. and (2) this device must accept any by Industry Canada. To reduce potential radio
interference. including
interference that may cause undesired operation
of the device.
interference to other users. the
antenna type and its gain should be so chosen
that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that
necessary for successful
communication.
Go ahead. take that call
We designed Go with a built-in
microphone. so you can use it as a
speakerphone. If you're connected to
your phone using Bluetooth. whenever a
call comes in. just press and release the
0 button to answer the call.
Momentarily pressing the 0 button
while you’re on a call will switch the call
on or off hold.
Pressing the 0 button for 1.5 seconds
will hang up an active cell.
You can even mute and unmute the
microphone by pressing the + and -
keys together while a call is active.
environment. This equipment should be Installed
and operated with minimum distance 20cm
between the radiator a your body. This transmitter
must not be co—Ioceted or operating In conjunction
with any other antenna or transmitter.
Canadian Compliance Declaration
(6
EU Declaration of Confonnlty
Simple Audio hereby declares that this portable
Bluetoolh speaker is in compliance with the
essential requirements and other relevant
provisions of Directive 1999/5/EC and Directive
2011/65IEU. You may request copy ofthe original
EU Declaration of Conformity by emailing
regulatoryfleimpleaudiocom
Conforme’ment a la re’glementation d'lndustrie
Canada, Ie present émetteur
radio peut fonctionner avec une antenne d'un type
et d'un gain maximal (ou inf
erieur) approuve pour I'emetteur par Industrie
Canada. Dans Ie but de reduire les
risques de brouillage radioélectrique a l'intention
des autres utilisateurs. iI
Lightmeup
There's an LED tucked discreetly behind
the front grille to give you at-a-glance
information about your Go speakers.
Solid blue Connected
Hashing red/bile Pairing mode
Slow flashing blue ....... Waiting to connect
Breathing blue Charging
Solid red ..................... Battery low
Recycling and Disposal Information
Your Simple Audio product uses advanced
electronics, and may include a rechargeable
battery. We encourage you to minimize your
impact on the environment by propeny disposing
of your used electronic hardware, rechargeable
batteries. and packaging.
Under European Union Directive
2002/96/EC. when you see this symbol on
— elecb'ical or elecbonic equipment.
packaging. or instnrction manuals. it means that
you must not dispose oftlre device as unsorted
municipal waste. You are obligated to dispose of
the device at public collection points set up for
this purpose, as defined by your national laws. By
retarding or reusing packaging and devices. you
are helping protect our environment
Simple Audio Two-Year Limited
Warranty Summary
Simple Audio warrants the Included hardware and
accessories against defects In materials and
workmanship tortwo-years from the date of
original purchase. Simple Audio does not warrant
against nonnai wear and tear. nor for damage due
to abuse or accident. To obtain service. call
Simple Audio or visit us at www.slmpleaudlo.com.
Service options depend on the country where the
service Is requested. Full terms of the wananty.
along with detailed Information on obtaining
service are available at wwwslmpleaudlocom.
Warranty benefits are In addition to any rights
provided under local consumer laws.
Le present appareil est conforme aux CNR
d'lndustrie Canada applicables aux
appareils radio exempts de licence. L'exploitation
est autoris e e aux deux
conditions suivantes : (1) I'appareil ne doit pas
produire de brouillage. et (2)
I'utilisateur de I'appareil doit accepter tout
brouillage radioe’lectrique subi.
faut choisir Ie type d'antenne et son gain de sorte méme si |e brouillage est susceptible d'en
que la puissance isotrope rayonn
ee equivalente (p.i.r.e.) ne de’passe pas I'intensite
nécessaire a l'etablissement
d'une communication satisfaisante.
compromettre Ie fonctionnement.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
XMP Toolkit                     : 3.1-701
Modify Date                     : 2013:09:20 17:15:48+08:00
Create Date                     : 2013:09:20 17:15:35+08:00
Metadata Date                   : 2013:09:20 17:15:48+08:00
Creator Tool                    : Adobe Acrobat 7.0
Format                          : application/pdf
Document ID                     : uuid:e4bbfe8f-8c4d-4b0a-9c66-12fb92d5b038
Instance ID                     : uuid:3bb21935-93ea-46c9-83db-8a1eb868e820
Producer                        : Adobe Acrobat 7.0 Image Conversion Plug-in
Page Count                      : 1
Creator                         : Adobe Acrobat 7.0

EXIF Metadata provided by EXIF.tools