Cradlepoint S5A643A 2x2 Dual Band Concurrent AP User Manual Statement
Cradlepoint, Inc. 2x2 Dual Band Concurrent AP Users Manual Statement
Contents
- 1. Users Manual (Statement)
- 2. Users Manual
Users Manual (Statement)
Revision 1.0 23 Aug 2016 Document Part: 170709-000
SAFETY, REGULATORY, AND WARRANTY GUIDE
CRADLEPOINT IBR900LP6 MODEL: S5A643A
CRADLEPOINT IBR950LP6 MODEL: S5A648A
CRADLEPOINT IBR900NM MODEL: S5A644A
This important Safety, Regulatory, and Warranty Guide contains safety,
handling, disposal, regulatory, trademark, copyright, and software
licensing information.
Read all safety information below and operating instructions before
using the device to avoid injury.
FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
this equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC STATEMENT
For product available in the USA/Canada market, only channel 1-11
can be operated. Selection of other channels is not possible.
Operation of the 5 GHz WiFi radios is restricted to indoor use only.
FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed
and operated with minimum distance of 40 cm between the radiator
and your body.
This device and its antennas(s) must not be co-located or operating in
conjunction with any other antenna or transmitter except in
accordance with FCC multi-transmitter product procedures.
To comply with FCC regulations limiting both maximum RF output
power and human exposure to RF radiation, the maximum cellular
antenna gain must not exceed 3.3 dBi. For Operation in Band 30, the
maximum cellular antenna gain must not exceed 1.0 dBi. Vehicle
installations with external antennas are not permitted to transmit on
Band 30 – the device shall be configured for receive only on this Band
when installed in a vehicle.
To comply with FCC regulations limiting both maximum RF output
power and human exposure to RF radiation, the maximum WiFi
antenna gain must not exceed 5 dBi.
INDUSTRY CANADA STATEMENT
This device complies with Industry Canada license-exempt RSS
standards. Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause
undesired operation of the device.
For product available in the USA/Canada market, only channel 1-11
can be operated. Selection of other channels is not possible.
The device for the band 5150-5250 MHz is only for indoor usage to
reduce potential for harmful interference to co-channel mobile
satellite systems.
INDUSTRY CANADA RADIATION EXPOSURE STATEMENT
This equipment complies with IC radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and
operated with minimum distance of 40 cm between the radiator and
your body.
This device and its antennas(s) must not be co-located or operating in
conjunction with any other antenna or transmitter except in
accordance with IC multi-transmitter product procedures.
This radio transmitter (IC: 6921A-S5A643A, 2417C-MC7455) has been
approved by Industry Canada to operate with the antenna types listed
below with the maximum permissible gain and required antenna
impedance for each antenna type indicated. Antenna types not
included in this list, having a gain greater than the maximum gain
indicated for that type, are strictly prohibited for use with this device.
This device has been designed to operate with cellular antennas
having a maximum gain of 3 dBi. Antennas having a higher gain are
strictly prohibited per regulations of Industry Canada. The required
antenna impedance is 50 ohms.
These devices have been designed to operate with WiFi antennas
having a maximum gain of 5 dBi. Antennas having a higher gain are
strictly prohibited per regulations of Industry Canada. The required
antenna impedance is 50 ohms.
DÉCLARATION D’INDUSTRIE CANADA
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Pour les produits disponibles aux États-Unis / Canada du marché, seul
le canal 1 à 11 peuvent être exploités. Sélection d'autres canaux n'est
pas possible.
les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés
uniquement pour une utilisation à l’intérieur afin de réduire les
risques de brouillage préjudiciable aux systèmes de satellites mobiles
utilisant les mêmes canaux.
NOTE IMPORTANTE (POUR L’UTILISATION DE DISPOSITIFS MOBILES):
DÉCLARATION D’EXPOSITION AUX RADIATIONS
Cet équipement est conforme aux limites d'exposition aux
rayonnements IC établies pour un environnement non contrôlé. Cet
équipement doit être installé et utilisé avec un minimum de 40 cm de
distance entre la source de rayonnement et votre corps.
Cet appareil et son antenne (s) ne doit pas être co-localisés ou
fonctionnement en association avec une autre antenne ou
transmetteur.
Ce dispositive a ete concu pour fonctionner ave une antenna cellulaire
ayant un gain maximal de 3 dBi. Une antenne a gain plus eleve est
strictement interdite par les reglemnets d’Industrie Canada.
L’impedance d’antenne requise est de 50 ohms.
Ce dispositive a ete concu pour fonctionner ave une antenna WiFi
ayant un gain maximal de 5 dBi. Une antenne a gain plus eleve est
strictement interdite par les reglemnets d’Industrie Canada.
L’impedance d’antenne requise est de 50 ohms.
Revision 1.0 23 Aug 2016 Document Part: 170709-000
INFORMATION FOR EUROPE, DECLARATION OF COMPLIANCE
Cradlepoint, Inc. declares that this device is in compliance with the
essential requirements of the R&TTE Directive 1999/5/EC, Energy
Related Products Directive 2009/125/EC, Electromagnetic
Compatibility Directive 2014/30/EC, Low Voltage Directive
2014/35/EC, and RoHS2 Directive 2011/65/EU.
A copy of the original European DoC may be obtained from
Cradlepoint.com/product-certifications
RF Exposure Statement: To comply with RF Exposure requirements,
this equipment should be installed and operated with minimum
distance of 40 cm between the radiating device and your body.
RECYCLING AND ENVIRONMENTAL INFORMATION
To find information on Cradlepoint’s commitment to our environment
and how to responsibly recycle or recover Cradlepoint products at the
end of their useful life, please visit Cradlepoint.com/international.
SAFETY AND HAZARDS
This equipment is designed to operate in ambient temperatures up to
75 °C (167 °F). When operating in elevated ambient temperatures,
the surface of the equipment may exceed 60 °C and become too hot
to safely touch. Under this condition, this product must be installed in
a secured location that is not accessible to accidental touch, and
access to the device must be restricted to service persons or users
who possess the proper tool or key to access the device and have been
informed about the potential high surface temperatures and
instructed on how to safely handle and/or service the device.
Under no circumstances should the device be used in any areas
(a) where blasting is in progress,
(b) where explosive atmospheres may be present, or
(c) that are near (i) medical or life support equipment, or (ii) any
equipment which may be susceptible to any form of radio interference.
In such areas, the device MUST BE POWERED OFF AT ALL TIMES (since
the device otherwise could transmit signals that might interfere with
such equipment).
In addition, under no circumstances should the device be used in any
aircraft, regardless of whether the aircraft is on the ground or in flight.
In any aircraft, the device MUST BE POWERED OFF AT ALL TIMES since
the device otherwise could transmit signals that might interfere with
various onboard systems on such aircraft. Furthermore, under no
circumstances should the device be used by the driver or operator of
any vehicle. Such use of the device will detract from the driver’s or
operator’s control of that vehicle. In some jurisdictions, use of the
device while driving or operating a vehicle constitutes a civil and/or
criminal offense.
Due to the nature of wireless communications, transmission and
reception of data by the device can never be guaranteed, and it is
possible that data communicated or transmitted wirelessly may be
delayed, corrupted (i.e., contain errors), or totally lost. The device is
not intended for, and Cradlepoint recommends the device not be used
in any critical applications where failure to transmit or receive data
could result in property damage or loss or personal injury of any kind
(including death) to the user or to any other party. Cradlepoint
expressly disclaims liability for damages of any kind resulting from:
(a) delays, errors, or losses of any data transmitted or received using
the device; or
(b) any failure of the device to transmit or receive such data.
For proper and safe vehicle installations, the GPIO accessory cable
must be connected to a fused circuit in the vehicle. This fused circuit
requires a 3A fuse. If the supply connection is made directly to the
battery, the fuse should be installed in the positive lead. For North
America, a UL Listed fuse is to be used.
Warning: This product is only to be installed by qualified personnel.
Purchaser agrees to indemnify Cradlepoint against any liability or
damages caused to third parties as a result of Purchaser’s misuse or
misapplication of the Cradlepoint product.
OPEN SOURCE SOFTWARE
This product contains software distributed under one or more of the
following open source licenses: GNU General Public License Version 2,
BSD License, Net-SNMP License, and PSF License Agreement for Python
3.3. For more information on this software, including licensing terms
and your rights to access source code, contact Cradlepoint at
Cradlepoint.com/opensource.
WARRANTY INFORMATION
Cradlepoint, Inc. warrants this product against defects in materials
and workmanship to the original purchaser for a period of three (3)
years from the date of shipment. This warranty is limited to a repair
or replacement of the product, at Cradlepoint’s discretion, as
purchaser’s sole and exclusive remedy. Cradlepoint does not warrant
that the operation of the device will meet your requirements or be
error free. CRADLEPOINT MAKES NO OTHER WARRANTY, EITHER
EXPRESSED OR IMPLIED, WITH RESPECT TO THIS PRODUCT.
CRADLEPOINT SPECIFICALLY DISCLAIMS THE IMPLIED WARRANTIES
OR CONDITIONS OF MERCHANTABILITY, FITNESS FOR A PARTICULAR
PURPOSE, TITLE OR NON-INFRINGEMENT.
LIMITATION OF CRADLEPOINT LIABILITY
The information contained in this Safety, Regulatory, and Warranty
Guide is subject to change without notice and does not represent
any commitment on the part of Cradlepoint or its affiliates.
CRADLEPOINT AND ITS AFFILIATES HEREBY SPECIFICALLY DISCLAIM
LIABILITY FOR ANY AND ALL: (A) DIRECT, INDIRECT, SPECIAL,
GENERAL, INCIDENTAL, CONSEQUENTIAL, PUNITIVE OR EXEMPLARY
DAMAGES, INCLUDING WITHOUT LIMITATION FOR LOSS OF PROFITS
OR REVENUE OR OF ANTICIPATED PROFITS OR REVENUE ARISING
OUT OF THE USE OR INABILITY TO USE THE DEVICE, EVEN IF
CRADLEPOINT AND/OR ITS AFFILIATES HAVE BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES, AND EVEN IF SUCH DAMAGES ARE
FORESEEABLE; OR (B) CLAIMS BY ANY THIRD PARTY.
NOTWITHSTANDING THE FOREGOING, IN NO EVENT SHALL THE
AGGREGATE LIABILITY OF CRADLEPOINT AND/OR ITS AFFILIATES
ARISING UNDER OR IN CONNECTION WITH THE DEVICE, REGARDLESS
OF THE NUMBER OF EVENTS, OCCURRENCES, OR CLAIMS GIVING RISE
TO LIABILITY, EXCEED THE PRICE PAID BY THE ORIGINAL PURCHASER
OF THE DEVICE.
PRIVACY
Cradlepoint may collect general data pertaining to the use of
Cradlepoint products via your Internet connection (wired and/or
wireless) such as device ID/serial number, network status, IP address,
MAC address, operating system, browser type and version number,
etc., in order to provide you with better services, enhance user
experience, and improve performance.
OTHER BINDING DOCUMENTS; TRADEMARKS; COPYRIGHT
By activating or using your IBR900 or IBR950 device, you agree to be
bound by Cradlepoint’s Terms of Use, User License and other
applicable Legal Policies.
© 2016 Cradlepoint, Inc. All rights reserved. Cradlepoint is not
responsible for omissions or errors in typography or photography.
Cradlepoint, IBR900, IBR950, and the Cradlepoint logo are trademarks
of Cradlepoint, Inc. in the US and other countries. Other trademarks
are property of their respective owners.
ROUTER COMMUNICATION/DATA USAGE
The factory default configuration of the router is set to communicate
with Cradlepoint and other resources at regular intervals to access the
latest firmware and modem updates, clock synchronization (NTP), and
Enterprise Cloud Manager (ECM) membership. Such communication
may result in data usage and applicable charges regardless of whether
the router uses a wired or wireless Internet connection. To avoid such
data usage and potential charges, consult the following Knowledge
Base article:
http://knowledgebase.cradlepoint.com/articles/support/router-
communication-data-usage