Crate Amplifiers Psm6P Users Manual

PSM6P to the manual 86fe8b95-f627-4b9d-9d82-edc308421a9c

: Crate-Amplifiers Crate-Amplifiers-Psm6P-Users-Manual-424402 crate-amplifiers-psm6p-users-manual-424402 crate-amplifiers pdf

Open the PDF directly: View PDF .
Page Count: 20

Download
Open PDF In Browser	View PDF

User’s Guide
for the

C R AT E A U D I O

PSM6P
Powered Full Range Enclosures

Please read this guide
before using your new
powered speakers!

PSM6P

Powered Full Range Enclosures

Table of Contents:
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Important Saftety Instructions . . . . . . . . . . . . . . . . .3
The Input Plate . . . . . . . . . . . . . . . . . . . . . . . . . .4,5
Applications . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
System Block Diagram . . . . . . . . . . . . . . . . . . . . . .7
Technical Specifications . . . . . . . . . . . . .back cover

CAUTION

PRECAUCION

ATTENTION

RISK OF ELECTRIC SHOCK
DO NOT OPEN

RIESGO DE CORRIENTAZO
NO ABRA

RISQUE D'ELECTROCUTION
NE PAS OUVRIR

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER. NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

PRECAUCION: PARA REDUCIR EL RIESGO DE INCENDIOS O DESCARGAS
ELECTRICAS, NO PERMITA QUE ESTE APARATO QUEDE EXPUESTO A LA
LLUVIA O LA HUMEDAD. PARA DISMINUOIR EL RIESGO DE CORRIENTAZO.
NO ABRA LA CUBIERTA. NO HAY PIEZAS ADENTRO QUE EL USARIO PUEDO
REPARAR DEJE TODO MANTENIMIENTO A LOS TECHNICOS CALIFICADOS.

ATTENTION: PROTÉGEZ CET APPAREIL DE LA PLUIE ET DE L'HUMIDITÉ
AFIN D'ÉVITER TOUT RISQUE D'INCENDIE OU D'ÉLECTROCUTION. POUR
REDUIRE D'ELECTROCUTION NE PAS ENLEVER LE COUVERCLE. AUCUNE
PIECE INTERNE N'EST REPRABLE PAR L'UTILISATEUR. POUR TOUTE
REPARATION, S'ADRESSER A UN TECHNICIEN QUALIFIE.

IMPORTANT SAFETY INSTRUCTIONS
• READ, FOLLOW, HEED, AND KEEP ALL INSTRUCTIONS AND WARNINGS.
• DO NOT OPERATE NEAR ANY HEAT SOURCE AND DO NOT BLOCK ANY VENTILATION OPENINGS ON THIS APPARATUS. FOR
•
•
•
•
•
•
•
•
•

PROPER OPERATION, THIS UNIT REQUIRES 3” (75mm) OF WELL VENTILATED SPACE AROUND HEATSINKS AND OTHER AIR
FLOW PROVISIONS IN THE CABINET.
DO NOT USE THIS APPARATUS NEAR SPLASHING, FALLING, SPRAYING, OR STANDING LIQUIDS.
CLEAN ONLY WITH LINT-FREE DAMP CLOTH AND DO NOT USE CLEANING AGENTS.
ONLY CONNECT POWER CORD TO A POLARIZED, SAFETY GROUNDED OUTLET WIRED TO CURRENT ELECTRICAL CODES AND
COMPATIBLE WITH VOLTAGE, POWER, AND FREQUENCY REQUIREMENTS STATED ON THE REAR PANEL OF THE APPARATUS.
PROTECT THE POWER CORD FROM DAMAGE DUE TO BEING WALKED ON, PINCHED, OR STRAINED.
UNPLUG THE APPARATUS DURING LIGHTNING STORMS OR WHEN UNUSED FOR LONG PERIODS OF TIME.
ONLY USE ATTACHMENTS, ACCESSORIES, STANDS, OR BRACKETS SPECIFIED BY THE MANUFACTURER FOR
SAFE OPERATION AND TO AVOID INJURY.
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK OR FIRE, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE..
SERVICE MUST BE PERFORMED BY QUALIFIED PERSONNEL.
OUR AMPLIFIERS ARE CAPABLE OF PRODUCING HIGH SOUND PRESSURE LEVELS. CONTINUED EXPOSURE TO HIGH SOUND
PRESSURE LEVELS CAN CAUSE PERMANENT HEARING IMPAIRMENT OR LOSS. USER CAUTION IS ADVISED AND EAR PROTECTION IS RECOMMENDED IF UNIT IS OPERATED AT HIGH VOLUME.
EXPLANATION OF GRAPHICAL SYMBOLS:
EXPLICACION DE SIMBOLOS GRAFICOS:
EXPLICATION DES SYMBÔLES GRAPHIQUES:

2

"DANGEROUS VOLTAGE"

=

“VOLTAJE PELIGROSO”
"DANGER HAUTE TENSION"

"IT IS NECESSARY FOR THE USER TO REFER TO THE INSTRUCTION MANUAL"

=

“ES NECESARIO QUE EL USUARIO SE REFIERA AL MANUAL DE INSTRUCCIONES.”
"REFERREZ-VOUS AU MANUAL D'UTILISATION"

PSM6P

Powered Full Range Enclosures

Introduction:

Thank you for choosing the Crate Audio PSM6P Powered Full
Range enclosures. PSM6P speakers provide exceptional sound quality in a rugged, compact package and are suitable for a wide variety
of applications. Each PSM6P features an internal 50 watt power
amplifier with gain, eq and level controls. 1/4” Input and Aux Out
jacks allow for a variety of system configurations. (Some examples of
their application are shown on page 6.)
The moisture-resistant enclosures of the PSM6P are manufactured from a high-impact polymer to provide years of rugged use.
They feature an integrated handle and a 5/8” stand mount for secure
use with the Traveler PA speaker stands.
The PSM6P speakers feature a high efficiency dome tweeter and
a sturdy 6-1/2” low frequency driver for clear and faithful audio
reproduction.

IMPORTANT SAFETY INSTRUCTIONS:
1.Read, follow and keep these instructions. Heed all warnings.
2.This speaker is capable of producing high sound pressure levels that may cause
permanent hearing damage. User caution is advised and ear protection is recommended during use.
3.This speaker is designed for use on a level floor or mounted to the supplied
speaker stand. The use of a speaker stand may pose a risk of personal injury.
Installations are to be performed by a professional installer in accordance with
local building codes.
4.Speaker cables are a tripping hazard and must be routed out of traffic areas and
away from any possible accidental contact.
5.Do not expose this speaker to rain or moisture. Do not place liquid filled containers on this speaker. Clean only with a damp cloth.
6.Repair or service of this speaker should be performed only by qualified personnel.
3

PSM6P

Powered Full Range Enclosures

The Input Plate:

1

2
3
6
4
7
5

9
8

10

11

4

PSM6P

Powered Full Range Enclosures

1. POWER LED: This LED illuminates when the unit is on. The blue LED on
the front of the enclosure (not shown) also illuminates when the unit is on.
2. MIC/LINE: Use this switch to set the input for the type of source connected
to the Input jack of the PSM6P. For microphones, set the switch to the Mic
position (switch depressed). For line level signals, such as the output of a
mixer, set the switch to the Line position (switch out).
3. GAIN: Use this control to adjust the level of the input signal when the
Mic/Line switch (#2) is in the Mic position (switch depressed).
4. TONE: Use this control to adjust the equalization of input signal. Rotating
this control counter clockwise boosts the low frequencies, rotating this control
clockwise boosts the high frequencies.
5. VOLUME: Use this control to adjust the speaker’s output level.
6. INPUT: Use this jack to connect the signal source to the PSM6P - see
Applications on page 6.
7. AUX OUT: Use this jack to connect the PSM6P to the Input jack of another
PSM6P when using multiple cabinets - see Applications on page 6. The output
of this jack is unaffected by the Gain, Tone, and Volume controls (#3, 4, 5).
8. VOLTAGE SELECTOR: Use this switch to match the PSM6P to the AC line
voltage source.
9. FUSE: The PSM6P uses a fuse to help protect the unit from damage due to
overload conditions. If the fuse fails replace it only with the same size and
type as indicated on the panel. If the fuse fails repeatedly, check the AC line
voltage source and the unit’s Voltage Selector switch (#8). If the problem persists contact your Crate dealer.
10. POWER: Use this switch to turn the PSM6P on and off. The Power LED (#1)
and the front panel blue LED illuminate when the power is on.
11. AC LINE CORD: This grounded power cord is to be plugged into a
grounded power outlet, wired to current electric codes and compatible with
the voltage, power and frequency requirements stated on the rear panel. Do
not attempt to defeat the safety ground connection.

5

PSM6P

Powered Full Range Enclosures

Applications:
SAMPLE STEREO
CONFIGURATION:
PSM6P

PSM6P

INPUT
AUX OUT

LEFT OUT

INPUT
AUX OUT

RIGHT
OUT

CSX42FX

TO OPTIONAL
ADDITIONAL PSM6P

TO OPTIONAL
ADDITIONAL PSM6P

SAMPLE MONO
CONFIGURATION:
PSM6P

PSM6P

MONO OUT

INPUT
AUX OUT

CSX42FX

TO OPTIONAL
ADDITIONAL PSM6Ps

6

INPUT
AUX OUT

PSM6P

Powered Full Range Enclosures

System Block Diagram:

MIC/
LINE
INPUT

GAIN

TONE

VOLUME

HIGH FREQ
DRIVER

POWER
AMP
XO

LOW FREQ
DRIVER
AUX
OUT

7

PSM6P

Powered Full Range Enclosures

Technical Specifications:
Cabinet Type

Molded High-Impact Polymer

Power Handling

50W (RMS), 80W peak

Drivers

Low Frequency
High Frequency

6.5” woofer
Dome tweeter

Sensitivity

91dB (1W @ 1m)

Rated Maximum SPL

112dB

Frequency Response

80Hz - 20kHz

Controls

Gain, Tone, Volume; Mic/Line switch

Input / Aux Out Connectors

1/4” Input jacks

Power Requirements

120VAC, 60Hz, 70VA
100/115VAC, 50/60Hz, 70VA
230VAC, 50/60Hz, 70VA

Dimensions H x W x D

14.17”H x 7.88”W x 9.12D”
36cm x 20cm x 23.2cm

Weight

15.4 lbs
7 kg

Stand Mount

5/8”

Specifications subject to change without notice.

www.crateaudio.com

©2003 SLM Electronics, Inc. • A Division of St. Louis Music, Inc.
1400 Ferguson Avenue • St. Louis, MO 63133
47-861-01 • 101003



---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : Yes
Create Date                     : 2003:10:16 14:57:35
Producer                        : Acrobat Distiller 4.05 for Macintosh
Modify Date                     : 2003:10:16 14:57:40-05:00
Page Count                      : 20

EXIF Metadata provided by EXIF.tools