D Link SHG200A1 Omna Bridge User Manual

D Link Corporation Omna Bridge

User Manual

DSH-G200 D-Link Corporation Page 1 DSH-G200 Omna Z-Wave Bridge User’s Manual Version 1.0 May. 12th, 2017
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Note: The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation
channels only. Industry Canada statement: This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d’ ISED applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable. Caution : (i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems; (ii) the maximum antenna gain permitted for devices in the band 5725-5850 MHz shall be such that the equipment still complies with the e.i.r.p. limits specified for point-to-point and non-point-to-point operation as appropriate; and (iii) Users should also be advised that high-power radars are allocated as primary users (i.e. priority users) of the bands 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices. Avertissement: (i) les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux; (ii) le gain maximal d'antenne permis (pour les dispositifs utilisant la bande de 5725 à 5 850 MHz) doit être conforme à la limite de la p.i.r.e. spécifiée pour l'exploitation point à point et l’exploitation non point à point, selon le cas; (iii) De plus, les utilisateurs devraient aussi être avisés que les utilisateurs de radars de haute puissance sont désignés utilisateurs principaux (c.-à-d., qu’ils ont la priorité) pour les bandes 5650-5850 MHz et que ces radars pourraient causer du brouillage et/ou des dommages aux dispositifs LAN-EL.
Radiation Exposure Statement: This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Déclaration d'exposition aux radiations: Cet équipement est conforme aux limites d'exposition aux rayonnements ISED établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20 cm de distance entre la source de rayonnement et votre corps. 低功率電波輻射性電機管理辦法低功率電波輻射性電機管理辦法低功率電波輻射性電機管理辦法低功率電波輻射性電機管理辦法 第十二條 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。 第十四條 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。 前項合法通信，指依電信法規定作業之無線電通信。 低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。 「電磁波曝露量MPE標準值1mW/cm2，本產品使用時建議應距離人體 20 cm」
DSH-G200 D-Link Corporation Page 2 Table of Contents 1. PRODUCT DESCRIPTION .................................................................................. 3 2. APPEARANCE ..................................................................................................... 3 3. APPLICATIONS ................................................................................................... 4 4. INSTALLATIONS & BASIC CONFIGURATIONS ........................................... 4
DSH-G200 D-Link Corporation Page 3 1. PRODUCT DESCRIPTION The DSH-G200 is a Z-Wave smart home bridge supporting S2 security and working with Apple HomeKit app to manage Z-Wave nodes to communicate with other HomeKit related devices. 2. APPEARANCE Top  LED: Status indicator  Wireless button: Z-Wave pairing/un-pairing Rear  LAN port x1  Micro USB: Power jack, 5V/1.A or 1.2A Bottom  Reset button Mounting installation
DSH-G200 D-Link Corporation Page 4 3. APPLICATIONS 4. INSTALLATIONS & BASIC CONFIGURATIONS Step 1 Make sure your DSH-G200 is powered on and near by your iOS devices. Step 2 Open Home and tap “Add Accessory” or tap to add the DSH-G200 to your home.
DSH-G200 D-Link Corporation Page 5 Step 3 Wait for the DSH-G200 to appear, then tap it. (Note: If asked to Add Accessory to Network, tap “Allow”.) Step 4 Scan the eight-digit HomeKit code on the DSH-G200 or its documentation. Or enter the code manually. Step 5 Add information about your DSH-G200, like its name or the room it's located in. Siri will identify the DSH-G200 by the name you give it and the location it's in. Step 6 Tap “Next”, then tap “Done” to finish the setup. Note: 1. Press the wireless button to enter inclusion mode to include Z-Wave nodes. 2. Press the wireless button for more than 5 seconds to enter exclusion mode to remove Z-Wave nodes.

Navigation menu