DEI Sales Polk Audio OMNISB1PLUSRX Sub-woofer User Manual For OMNI SB1 SOUNDBAR SUB 0714

Polk Audio Sub-woofer For OMNI SB1 SOUNDBAR SUB 0714

Contents

User Manual (Statements) rev 2

Download: DEI Sales Polk Audio OMNISB1PLUSRX Sub-woofer User Manual For OMNI SB1 SOUNDBAR SUB  0714
Mirror Download [FCC.gov]DEI Sales Polk Audio OMNISB1PLUSRX Sub-woofer User Manual For OMNI SB1 SOUNDBAR SUB  0714
Document ID3063671
Application ID8V+4FNyidmoRLS3+6+ITLg==
Document DescriptionUser Manual (Statements) rev 2
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize2.21kB (27632 bits)
Date Submitted2016-07-14 00:00:00
Date Available2016-07-14 00:00:00
Creation Date2016-07-14 08:51:29
Producing SoftwarePDFCreator 2.3.0.103
Document Lastmod2016-07-14 13:12:11
Document TitleFor OMNI SB1 SOUNDBAR&SUB -0714
Document CreatorPDFCreator 2.3.0.103
Document Author: A93038

For SOUNDBAR
Operations in the 5.15-5.25GHz band are restricted to indoor
usage only.
Federal Communications Commission Interference
Statement
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including
interference that may cause undesired operation.
FOR MOBILE DEVICE USAGE Radiation Exposure
Statement:
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the
radiator & your body.
CAUTION:
Any changes or modifications not expressly approved by the
grantee of this device could void the user’s authority to operate
the equipment.
FOR COUNTRY CODE SELECTION USAGE (WLAN DEVICES)
Note: The country code selection is for non-US model only and is
not available to all US model. Per FCC regulation, all Wi-Fi
product marketed in US must fixed to US operation channels only.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for
help.
Industry Canada statement:
This device complies with ISED’s licence-exempt RSSs.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Caution:
(i) the device for operation in the band 5150-5250 MHz is only for
indoor use to reduce the potential for harmful interference to
co-channel mobile satellite systems;
(ii) the maximum antenna gain permitted for devices in the bands
5250-5350 MHz and 5470-5725 MHz shall be such that the
equipment still complies with the e.i.r.p. limit;
(iii) the maximum antenna gain permitted for devices in the band
5725-5850 MHz shall be such that the equipment still complies
with the e.i.r.p. limits specified for point-to-point and
non-point-to-point operation as appropriate; and
(iv) the worst-case tilt angle(s) necessary to remain compliant
with the e.i.r.p. elevation mask requirement set forth in Section
6.2.2(3) shall be clearly indicated.
(v) Users should also be advised that high-power radars are
allocated as primary users (i.e. priority users) of the bands
5250-5350 MHz and 5650-5850 MHz and that these radars could
cause interference and/or damage to LE-LAN devices.
Radiation Exposure Statement:
This equipment complies with ISED radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the
radiator & your body.
Le présent appareil est conforme aux CNR d’ ISED applicables
aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes: (1) le dispositif ne doit
pas produire de brouillage préjudiciable, et (2) ce dispositif doit
accepter tout brouillage reçu, y compris un brouillage susceptible
de provoquer un fonctionnement indésirable.
Avertissement:
Le guide d’utilisation des dispositifs pour réseaux locaux doit
inclure des instructions précises sur les restrictions
susmentionnées, notamment :
(i) les dispositifs fonctionnant dans la bande 5150-5250 MHz
sont réservés uniquement pour une utilisation à l’intérieur afin de
réduire les risques de brouillage préjudiciable aux systèmes de
satellites mobiles utilisant les mêmes canaux;
(ii) le gain maximal d'antenne permis pour les dispositifs utilisant
les bandes de 5250 à 5 350 MHz et de 5470 à 5725 MHz doit être
conforme à la limite de la p.i.r.e;
(iii) le gain maximal d'antenne permis (pour les dispositifs
utilisant la bande de 5 725 à 5 850 MHz) doit être conforme à la
limite de la p.i.r.e. spécifiée pour l'exploitation point à point et
l’exploitation non point à point, selon le cas;
(iv) les pires angles d’inclinaison nécessaires pour rester
conforme à l’exigence de la p.i.r.e. applicable au masque
d’élévation, et énoncée à la section 6.2.2 3), doivent être
clairement indiqués.
(v) De plus, les utilisateurs devraient aussi être avisés que les
utilisateurs de radars de haute puissance sont désignés
utilisateurs principaux (c.-à-d., qu’ils ont la priorité) pour les
bandes 5250-5350 MHz et 5650-5850 MHz et que ces radars
pourraient causer du brouillage et/ou des dommages aux
dispositifs LAN-EL.
Déclaration d'exposition aux radiations:
Cet équipement est conforme aux limites d'exposition aux
rayonnements ISED établies pour un environnement non contrôlé.
Cet équipement doit être installé et utilisé avec un minimum de 20
cm de distance entre la source de rayonnement et votre corps.
For SUBWOOFER
Federal Communications Commission Interference
Statement
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Caution:
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate this equipment.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the
radiator & your body.
Industry Canada statement:
This device complies with ISED’s licence-exempt RSSs.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Radiation Exposure Statement:
This equipment complies with ISED radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the
radiator & your body.
Le présent appareil est conforme aux CNR d’ ISED applicables
aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes: (1) le dispositif ne doit
pas produire de brouillage préjudiciable, et (2) ce dispositif doit
accepter tout brouillage reçu, y compris un brouillage susceptible
de provoquer un fonctionnement indésirable.
Déclaration d'exposition aux radiations:
Cet équipement est conforme aux limites d'exposition aux
rayonnements ISED établies pour un environnement non contrôlé.
Cet équipement doit être installé et utilisé avec un minimum de 20
cm de distance entre la source de rayonnement et votre corps.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Encryption                      : Standard V2.3 (128-bit)
User Access                     : Print, Copy, Extract
Page Mode                       : UseNone
XMP Toolkit                     : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:14:39
Producer                        : PDFCreator 2.3.0.103
Keywords                        : 
Modify Date                     : 2016:07:14 13:12:11+08:00
Create Date                     : 2016:07:14 08:51:29+08:00
Creator Tool                    : PDFCreator 2.3.0.103
Metadata Date                   : 2016:07:14 13:12:11+08:00
Document ID                     : uuid:996d6a9e-4bb8-11e6-0000-0c9cc3b6133a
Instance ID                     : uuid:aaf266bc-6f5a-46a4-bf54-979e3209ed99
Format                          : application/pdf
Title                           : For OMNI SB1 SOUNDBAR&SUB -0714
Creator                         : A93038
Description                     : 
Page Count                      : 3
Page Layout                     : SinglePage
Subject                         : 
Author                          : A93038
EXIF Metadata provided by EXIF.tools
FCC ID Filing: WLQOMNISB1PLUSRX

Navigation menu