DO Intelligent Technology ID130PLUSCOLOR Smart Bracelet User Manual

Shenzhen DO Intelligent Technology Co., Ltd. Smart Bracelet

User Manual

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interferencethat may cause undesired operation.CAUTIONRISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPEDISPOSE OF USED BATTERIES ACCORDINGTO THE INSTRUCTIONSOld electrical appliances must not be disposed of together with the residual waste, but have to be disposed of separately. The disposal at the communal collecting point via private persons is for free. The owner of old appliances is responsible to bring the appliances to these collecting points or to similar collection points. With this little personal effort, you contribute to recycle valuable raw materials and the treatment of toxic substances.Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:-- Reorient or relocate the receiving antenna.-- Increase the separation between the equipment and receiver.-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.-- Consult the dealer or an experienced radio/TV technician for help.Modes of exit: 1. Press and hold the touch key to exit from the camera mode2. Exit through App will make the wrist strap quit from the camera mode.Time Sports ModeData Mode Alarm Clock ModeHeart Rate ModeUse VeryFitPro on iOS or Android smart phone to setthe wristband as follows:Search and download “VeryFitPro” from the Apple Store or Android App store .The product must be activated by charging before initial use, and then charge the product to ensure normal power supply. The hand ring will automatically power on.Take out: Pull open the strap and take out the bracelet bodyCharge the battery: Insert the chip-mounted end of the bracelet body into the USB interface to activate the product by charging (be cautious not to reverse the polarity, and comply with the required voltage and current: 5V / 500mA)Installation: Mount the bracelet body into the slot of the wrist strap.Wear the device on your wrist horizontally, about 2cm to carpal,the same method as wearing watches.[Click the touch key] to enter the next mode:Sports Mode[Press and hold the touch key for 2s]to start/close alarm clock [Press and hold the touch key for 2s] to enter theSports Mode[Click the touch key] to enter the next sports mode; and in case there are no other sports modes, it will go back to the time mode.Note: Types of Sports mode can be selected in App (App can handle 4 types of track recording sports and 10 types of other activities)Note: Upon staying at the Heart Rate interface for 1s, start to monitor the heart rate, and a fig. like is displayed before the correct data is monitored, and upon the correct data being monitored, data is displayed.[Click the touch key] to enter the next mode: Alarm Clock ModeNote: Alarm clock function should be turned on in App for the alarm clock to be displayed.When selecting the right band from the search list, please slide the screen of wristband to wake up the device and then complete connecting. Single click the touch key: Interface switchPress and hold the touch key:Enter1、Wearing Method1.3 Heart Rate Mode1.4 Alarm Clock Mode 1.5.2 Sports Underway Mode1.5 Sports ModeAfter the countdown interface of 3-2-1-GOis the sports underway mode.[Click the touch key] to enter the next sub-mode of “Sports Underway”[Press and hold the touch key for 2s] to enter any interface of Data Reading, press and hold 2s to exit the sports mode.Note: The speed and distance of riding can be displayed, but App need to be connected and the riding and App needs to start at the same time.1.5.1 Sports Start ModeTo monitor Heart Rate more accurately, please wear the device on the upper position of your wrist and a bit tighter than usual when you are taking exercise. 2、Heart Rate Monitoring Continuously working for 8 days under normal conditions4、Working Time5、Interface Click the touch key to display successivelyAutomatic heart rate Monitoring is ON as default, monitor Heart Rate all the day automatically.3、Heart Rate MonitoringIt probably has a problem to open the link with WeChat or other scan tools, please copy the link and open it through browser.Note: hardware and system of devices should meet therequirements:iOS 7.0 & Above Android4.4 & Above Support Bluetooth4.01├Download VeryFitPro2、Product activation and installation 3、Touc h k e y4、Make sure the Bluetooth of smart phone is ON, open app“VeryFitPro”Search and downloadScan the QR code and download [Click the touch key] to enter the next mode: Heart Rate Mode [Press and hold the touch key for 2s] to enter the sub-mode of “Data Reading”[Click the touch key] to enter the next sub-modeNote：To go back to the Data ReadingMode by clicking the touch key on the final interface of Data Reading Sub-Mode1.1 Time Mode1.2 Data Mode1.2.1 Data Reading Sub-Mode InstructionsTime dial can be switched as follows: APP Devices Mode>More[Click the touch key] to enter the next mode: Data Mode（you can customize the shortcut through the app）Wear on: Adjust the length of the wrist strap until it is appropriate to wear on the wirst.Average pace Pace/Speed PmHeart Rate Steps Calories MileDuration, CaloriesStep, Distance Pace, Heart Rateor1）Reminder of exiting from sports mode upon a period of no activityUif!sfnjoefs!xjmm!cf!bwbjmbcmf!tppo2）Reminder of full-ram force quit Note1.If there is no any activity in a period (15 minutes), reminder will be displayed 15s before it stop.2.New activities will remove the reminder of automatic quitting from the sports mode.3.If there are no any new operations before the end of the countdown of automatic quitting from the sports mode, it will exit from the sports mode. [Click the touch key] to enter the main interface of sports mode (the data reading interface of sports data display mode is not displayed)1）If the sports last less than 1 minute, the user will be reminded of not saving the data. [Click the touch key] to enter the sports data display mode2）If the sports last more than 1 minute, theSports End Reminder will be displayed[Click the touch key] to enter the next sports data display mode, and the single click of the final interface will go back to the first interface of sportsmode. 3）Sports data display mode [Click the touch key] to remove the reminder of automatic quitting from sports mode.[Click the touch key] to confirm the full-ram Force QuitNote: When the memory of wrist strap is full of sports data, the user will be reminded of exiting from the Sports Mode3）Reminder of force quit for low-battery[Click the touch key] to accept the force quit from the sports modeNote: During the sports activities, when the power is toolow, the sport mode will pause, and remind the user of force quit from the sports mode.4）Reminder of inaccessible sport mode for low-battery 1）Call Reminder2）Message Reminder[Click the touch key] to accept the inaccessible sportsmode for low-batteryNote: The reminder will occur when a user tried to start the sports mode with the battery of device is in low. ◆ Failed to find the device when pairing◆ How to restore factory defaults◆ Failed to connect with Bluetooth occasionally1.5.3 Sports Stop Mode1.5.4 Event Reminder in Sports Mode1.5.5 Abnormal operations during activityModel No.: ID130Plus Color HRBattery Capacity: 70mAhWorking Voltage: 3.7V Host weight: about 22.5g Sync: Bluetooth 4.0 Working temperature: －10℃- 45℃Waterproof: IP67Working Time: 7daysProduct frequency band: 2402-2480MHzMaximum transmit power: -4.05dBm① Make sure the Bluetooth of smart phone is ON, and smart phoneOS Android 4.4 & Above, iOS 7.0 & Above.② Make sure the distance between phone and device is within 0.5meter, device is among the normal Bluetooth communication distance range(within 10meter) after pairing finished.③ Make sure the device is not under low battery. If there is still a problem after fully charged, please contact us.Make sure the device is connected with smart phone, go in the App, enter “device-- System setting”, and choose “reboot device”.① Caused by the abnormality of Bluetooth service when it restarted on the phone.② Reboot mobile phone or re-start the Bluetooth service, then it works normal.The device meets the EU ROHS criterion. Please refer to IEC 62321, EU ROHS Directive2011/65/EU and revised directive.[Click the touch key] to quit from the reminder waiting modeEntry mode: Start the camera entry by App, and the device will get in the camera mode successfully.Photo taking methods: shake/wrist lifting/click the touch keyClick the touch key to remove the call reminder Press and hold the touch key to hang up the callNote: The call reminder in the App needs to be set open.In case of pages of messages, Click the touch key to read the remained ones.Note: The relevant settings need to done in the App.3）Alarm Clock4)Long Sitting Reminder5) Target completion reminderAlarm Clock: The relevant settings need to done in the App.Alarm Clock Reminder: The relevant settings need to done in the App..Click the touch key: It will remove thereminder.When some goals are achieved, shake the wrist strap to get the interface of target completion reminder displayed Click the touch key to quit from the reminder1. Camera mode control2. More modes of reminders6）Low battery reminder7）Device Error NotificationLow-Battery! Please recharge timely!Note: When the device is detected with an abnormality, the interface herein will bedisplayed each time the device is opened.Status Code:-01 means the abnormality of acceleration sensor-02 means the abnormality of heart rate sensor-03 means the abnormality of touch key IC-04 means the abnormality of flashWake up Medicine taking Sleeping PartyAppointment Exercise MeetingAlarm Clock Types: 12 13 14 15 16 17 18 19 1: 21 22 23 24 25SettingBefore Data Is Displayed After DataIs DisplayedChange in 0.5sKnow your DeviceFunction IntroductionAdd DeviceDetection failed,please re search/*6R[Y)URUXBasic SpecificationsDeclaration of toxic and hazardous substances in electronic information productsFAQդ०ؾت ^SS/*6R[Y)URUX.8પޢа ߕૅ Mୢߡ঻੸ઌސڔ ਇ੸ோ਩ ֚਩Յவ࣍ߎ՚ <User GuideID130Plus Color HRThanks for choosing our device, please read the user guide carefully before using.Smart Bracelete EU 2321sed ddous

Navigation menu