DSI 48417 Single Channel Family Radio Service Transmitter User Manual

Download:
Mirror Download [FCC.gov]
Document ID	322824
Application ID	rFmAGGaJVq4hYmn9wD3upA==
Document Description	User manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	6.04kB (75538 bits)
Date Submitted	2003-05-02 00:00:00
Date Available	2003-05-02 00:00:00
Creation Date	2003-02-18 14:39:50
Document Lastmod	2003-03-18 16:42:20
Document Title	User manual
Document Creator	HP 9100C Digital Sender
Document Author:	ITS ELECTRIC TOY

FCC Warning
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two oonditions: (I) this
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation
11m user is cautioned tlut changes or modifications not expressly approved by
the muflcturer could void the user’s authority to operate the equipment.
INSTRUCTION SHEET FOR 48413 WRIST WALKIE TALIGE
1. Open the battery door and insert the LR44 dz LR41 button cells according to the
diagram shown
2. Push the “Power" button on the right hand side of the walkie talkie downwards to
tum on the walkie talkie
3. Press the “Talk" button, now the walkie talkie is in TX sums, & can communicate
with another walkie talkie,
4 If necessary, plug in the mono headphone to the “SPK” position for listening.
5, To adjust the time of the watch, use the “Set Up” and “Mode" buttons on the LCD
panel
CAUTION
To ensure proper filnction and battery leakage:
- Do not mix old and new button cells,
- Do not mix alkaline, standard button cells.
- Button cells are to be inserted with the correct polarity.
- Only lmtton cells of the same or equivalent type as recommend are to he used.
Item No. 48417
USER MANUAL
WARNING: Adjustment to this unit or replacement of any transmitter
component (crystal, semiconductor. etc.) to this unit could result' in a
violation of the rules.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device. pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a
residential installation This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, mere is no guarantee that interference will not occur in a particular
installation If this equipment does muse harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
D Reorient or relocate the receiving antenna.
D Increase the separation between the equipment and receiver.
D Connect the equipment into an outlet on a circuit different from that to
which the receiver is needed.
D Consult the dealer or an experienced radio/TV technician for help.
SAFETY INFORMAflON
Your wireless hand-held portable transceiver contains a low power transmitter. When
the Push-to-Talk (PTI') button is pushed it sends out radio frequency (RF) signals. In
August 1996, the Federal Communications Commissions (FCC) adopted RF exposure
guidelines with safety levels for hand-held wireless devices.
IMPORTANT: To maintain compliance with the FCC's RF exposure guidelines hold the
transmitter and antenna at lest 1 inch (2.5 centimeters) from your face and speak in a
normal voice, with the antenna pointed up and away from the face. If you wear the
handset on your body while using the headset accessory. use only the supplied belt
dip for this product and when transmitting, take it out of the belt to ensure that the
antenna is at least 1 inch (2.5 centimeters) from your body.
Use only the supplied antenna. Unauthorized antennas, modifications, or attachments
could damage the transmitter and may violate FCC regulations.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Creator                         : HP 9100C Digital Sender
Create Date                     : 2003:02:18 14:39:50
Author                          : ITS ELECTRIC TOY
Producer                        : 
Title                           : 
Subject                         : 
Modify Date                     : 2003:03:18 16:42:20+08:00
Page Count                      : 3

EXIF Metadata provided by EXIF.tools