Darfon Electronics M300 RF Wireless Optical Mouse User Manual
Darfon Electronics Corp RF Wireless Optical Mouse
User Manual
User’s Manual Guide Hardware Installation 1.Connecting the receiver module For USB Interface - Plug the receiver cable into the USB port of your system. - System will automatically detect for new hardware. Follow system instruction for setup For USB and PS/2 Combo (If no USB port) - Connect the PS/2 adaptor to the USB connector of the receiver. - Restart your system. Note: For optimal performance, place the receiver at least 8 inches (20 cm) away from any electronics devices (ex. computer, monitor, etc.) to avoid interference. If placing the receiver on metal surface, please use a non-metal pad under it. 2. Load batteries in optical mouse ( 2 AA batteries) 3. Syncranizing the receiver and wireless mouse 1. Setup the Mouse channel to channel 1 or channel 2. 2. Setup the Receiver channel to channel 1 or channel 2. Note: There are 2 channels for this mouse. Please make sure the mouse and the receiver are in the same channel ! Mice Setting From Start Menu to select Settings / Control Panel / Mouse to change your mouse settings. Note: This mouse applies 800 CPI optical module. It will move faster than normal optical mouse. Please change moving speed from mice setting. Troubleshooting Mouse does not work 1. Make sure the receiver cable is connected to the port correctly. 2. Check battery. Cautions 3. Make sure the mouse and receiver are in the same channel. Long periodssure of repetitive motion using a mouse with physical discomfort and 4. Make your mouse in not sitting on amay redbe orassociated highly reflective surface (ex. injuryMirror, in yourglass, hands,etc.) wrists, arms, shoulders, neck, or back. To reduce the risk of injury, we suggest taking frequent short breaks and keep your shoulders relaxed. This product has been tested to comply with international standard IEC 825-1:1993 Information to User Notice 1 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. Notice 2 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : No Create Date : 2003:01:07 17:46:16+08:00 Modify Date : 2003:01:07 17:46:16+08:00 Page Count : 3 Creation Date : 2003:01:07 09:46:16Z Mod Date : 2003:01:07 09:46:16Z Producer : Acrobat Distiller 5.0 (Windows) Metadata Date : 2003:01:07 09:46:16ZEXIF Metadata provided by EXIF.tools