Datalogic S r l 0022 915MHz radio module User Manual

Datalogic ADC S.r.l. 915MHz radio module

User manual

Download: Datalogic S r l 0022 915MHz radio module User Manual
Mirror Download [FCC.gov]Datalogic S r l 0022 915MHz radio module User Manual
Document ID2189337
Application IDzr+SdQJ9HTrpJ3PzY8sngw==
Document DescriptionUser manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize64.2kB (802449 bits)
Date Submitted2014-02-14 00:00:00
Date Available2014-02-17 00:00:00
Creation Date2014-02-11 12:30:44
Producing SoftwareMicrosoft® Word 2010
Document Lastmod2014-02-14 10:18:06
Document TitleUser manual
Document CreatorMicrosoft® Word 2010
Document Author: Davide.Carli@datalogic.com

Author: Radio Group
Date:
February 11th, 2014
Subject: Integration Guide – Mizar Radio Module 915 MHz
Integration Guide
Mizar Radio Module 915 MHz
Page 1 of 8
Author: Radio Group
Date:
February 11th, 2014
Subject: Integration Guide – Mizar Radio Module 915 MHz
Table of contents
Document history ...................................................................................................... 3
Introduction ............................................................................................................... 4
Pinout ........................................................................................................................ 4
Block diagram ............................................................................................................ 4
Operational description ............................................................................................. 5
Working modes.............................................................................................................................................. 5
Functional states ........................................................................................................................................... 5
Idle State .................................................................................................................................................... 5
Receive State ............................................................................................................................................. 5
Transmission State..................................................................................................................................... 5
Interface description (pinout reference) .................................................................... 6
Electrical characteristics ............................................................................................. 7
RF characteristics ....................................................................................................... 7
Low speed mode ............................................................................................................................................ 7
High speed mode ........................................................................................................................................... 8
Page 2 of 8
Author: Radio Group
Date:
February 11th, 2014
Subject: Integration Guide – Mizar Radio Module 915 MHz
Document history
Date
Author
Notes
April 19th, 2012
May 2nd, 2012
May 31th, 2012
July 18th, 2012
April 15th, 2013
Davide Carli
Davide Carli
Davide Carli
Davide Carli
Davide Carli
December 20th, 2013
Davide Carli
January 15th, 2014
February 11th, 2014
Davide Carli
Pier Giorgio Peruzzi
Initial draft
Added details on test command(s) 0x86
In-depth documentation of test commands
Added data on current consumption in DEEP SLEEP status
Updated the description of some test commands
Document splitted in 433 MHz and 915 MHz versions
RF Characteristics updated according to FW 2.01A and 2.01B
Removed outdated information
RF Characteristics updated according to FW 2.02B
Added Operational description and Interface description
Page 3 of 8
Author: Radio Group
Date:
February 11th, 2014
Subject: Integration Guide – Mizar Radio Module 915 MHz
Introduction
Mizar radiofrequency (RF) module operates in the 902-928 MHz ISM frequency band.
Pinout
Block diagram
Page 4 of 8
Author: Radio Group
Date:
February 11th, 2014
Subject: Integration Guide – Mizar Radio Module 915 MHz
Operational description
The equipment is a radio module to be integrated inside cordless devices.
It is based upon an FSK ( Frequency Shift Keying Modulation ) Half-Duplex transceiver working in the ISM
band from 902 to 928 MHz.
The radio module has a UART interface to exchange data and commands.
Working modes
Radio module can operate in the follow working modes :
Low Speed, Low Power, fixed channel (among 25 channels)
o FSK, Bitrate 36864 bps, RZ Manchester encoded, Frequency deviation +/- 75KHz
Low Speed, Frequency Hopping Mode over 25 channels
o FSK, Bitrate 36864 bps, RZ Manchester encoded, Frequency deviation +/- 75KHz
High Speed, Digital Transmission Mode, fixed channel (among 12 channels)
o FSK, Bitrate 500,000 bps, NRZ, Frequency deviation +/- 220KHz
High Speed, Digital Transmission + frequency agility Mode over 12 channels
o FSK, Bitrate 500,000 bps, NRZ, Frequency deviation +/- 220KHz
Default mode after power-up is Low Speed Low Power mode.
Radio module can receive commands to allow to change its working mode.
Functional states
Radio module can be set in one of the following states during operation:
Idle State
Radio module stays in low power receiving mode with a limited capability to receive data. RF transmission
is not allowed while radio is set in Idle state.
Receive State
It is the normal default state. In this state the radio receives the RF packets, decodes the packets and sends
them to the Host device. In this mode the transceiver checks continuously the RF signal and demodulates
it. The demodulated and filtered signal is sent to the microcontroller inside the radio module which
decodes it and sends decoded data to the Host by means of the UART interface. Only valid demodulated
data packets are sent to the Host.
Transmission State
This state is enabled from the host when it needs to transmit data. The transmission state is enabled
sending a data packet to the radio module over the UART interface. The microcontroller in the radio
module checks for the integrity of the data packet and enables the transceiver to modulate and transmit to
the RF interface, preceded by a short preamble burst. Radio module exits automatically from this state
when the complete packet has been transmitted, and returns to the receive state.
Page 5 of 8
Author: Radio Group
Date:
February 11th, 2014
Subject: Integration Guide – Mizar Radio Module 915 MHz
Radio module operates in CSMA-CA (carrier sense multiple access – collision avoidance) : transmission is
enabled when the RF channel is not busy by the use of a “carrier detect” function. Radio module accesses
the channel in a fair way using a backoff algorithm.
Interface description (pinout reference)
UART 2-pin interface, used to exchange data from the Host:
DATA_OUT (output pin) : transmits data to Host.
DATA_IN (input pin) : receives data from Host.
CD# – (output pin) Carrier Detect :
When radio is in receive mode, this pin signals the presence of RF carrier.
IDLE - (input pin) :
A high level on this pin forces the radio module in Idle State.
RESET (input pin) :
A low level on this pin resets the radio module.
VCC and GND :
Radio module power supply.
RF Port :
Radio Frequency Connector for the antenna.
Page 6 of 8
Author: Radio Group
Date:
February 11th, 2014
Subject: Integration Guide – Mizar Radio Module 915 MHz
Electrical characteristics
Table 1
Parameter
Min. Typ. Max. Unit
Power supply voltage (between VCC pin and GND pin) 3,1
3,3
3,6
Operating temperature range
-30
--+85
°C
RF characteristics
Low speed mode
Table 2
Table 3
Parameter
Typ. value
Unit
Modulation
RZ Manchester
Bit rate (over-the-air)
36864 bit/s
Frequency deviation
± 75,000 kHz
Number of supported channels
25
Index of default channel
Center frequency of default channel
910,00000 MHz
Channel
index
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
Channel
center
frequency
[MHz]
902,80050
903,82900
904,85750
905,88600
906,91450
907,94300
908,97150
910,00000
911,02850
912,05700
913,08550
914,11400
915,14250
916,17100
917,19950
918,22800
919,25650
920,28500
921,31350
922,34200
923,37050
924,39900
925,42750
926,45600
927,48450
Page 7 of 8
Author: Radio Group
Date:
February 11th, 2014
Subject: Integration Guide – Mizar Radio Module 915 MHz
High speed mode
Table 6
Table 7
Parameter
Typ. value Unit
Modulation
NRZ
Bit rate (over-the-air)
500000 bit/s
Frequency deviation
± 220,000 kHz
Number of supported channels
12
Index of default channel
Center frequency of default channel 910,00000 MHz
Channel
index
10
11
12
Channel
center
frequency
[MHz]
903,64900
905,76600
907,88300
910,00000
912,11700
914,23400
916,35100
918,46800
920,58500
922,70200
924,81900
926,93600
Page 8 of 8
Federal Communications Commission (FCC) Statement
You are cautioned that changes or modifications not expressly approved by the part responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received, including interference that may cause undesired
operation of the device.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Industry Canada (IC) Statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Canada, avis d’Industry Canada (IC)
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Caution: Exposure to Radio Frequency Radiation.
To comply with RSS 102 RF exposure compliance requirements, a separation distance of at least 20 cm
must be maintained between the antenna of this device and all persons.
Pour se conformer aux exigences de conformité CNR 102 RF exposition, une distance de séparation d'au
moins 20 cm doit être maintenue entre l'antenne de cet appareil et toutes les personnes
End Product Labeling:
The final end product must be labeled in a visible area with the following:
“Contains FCC ID: U4F0022, IC: 3862D-006”.
Antenna list:
Rubber Antenna
P/N: ANT-916-CW-QW
Rubber Antenna
P/N: G-RA0K14155047-BON
Printing Antenna
P/N: 663316020

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
Author                          : Davide.Carli@datalogic.com
Create Date                     : 2014:02:11 12:30:44+01:00
Modify Date                     : 2014:02:14 10:18:06+08:00
Language                        : it-IT
Tagged PDF                      : No
XMP Toolkit                     : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26
Format                          : application/pdf
Creator                         : Davide.Carli@datalogic.com
Creator Tool                    : Microsoft® Word 2010
Metadata Date                   : 2014:02:14 10:18:06+08:00
Producer                        : Microsoft® Word 2010
Document ID                     : uuid:0984e024-5eff-4daf-9011-f751bda35500
Instance ID                     : uuid:77d6d844-6bf8-404d-aebe-3dec9838e5be
Page Count                      : 11
EXIF Metadata provided by EXIF.tools
FCC ID Filing: U4F0022

Navigation menu