Davis Instruments DWW7617 ConsoleLink, Model 7617 User Manual ConsoleLink for FCC

Download:
Mirror Download [FCC.gov]
Document ID	56342
Application ID	E5z/X6RsAWM4yyJA/RNz9w==
Document Description	Installation manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	4.56kB (56959 bits)
Date Submitted	1999-08-25 00:00:00
Date Available	1999-11-18 00:00:00
Creation Date	1999-08-05 11:44:45
Producing Software	Acrobat Distiller 3.01 for Power Macintosh
Document Lastmod	1999-08-23 17:15:33
Document Title	ConsoleLink for FCC
Document Creator	FrameMaker 5.5.3

CONSOLELINK
INSTALLATION MANUAL
The ConsoleLink Transmitter (Tx) connects to a host Weather Monitor II,
Weather Wizard II & III, or Perception II. The ConsoleLink Tx transmits
weather data from your host station to other DavisTalk™ compatible consoles
and receiving units. This allows you to send weather data to one or more locations without using any wires.
Providing you have the necessary sensors, the ConsoleLink Tx will send the
following weather data:
Weather Monitor
II
Weather Wizard
II and III
Perception
Inside Temperature
Yes
Yes
Yes
Inside Humidity
Yes
No
Yes
Outside Temperature
Yes
Yes
No
Outside Humidity
Yes
No
No
Rainfall
Yes
Yes
No
Wind Speed
Yes
Yes
No
Wind Direction
Yes
Yes
No
Barometer
Yes
No
Yes
The ConsoleLink Tx is user-configurable to communicate on one of 8 different
ID codes. This allows multiple systems to coexist in the same geographical
area. The unit includes a pass-thru connector so that a WeatherLink data logger
can still be used with the host station.
Note: The ConsoleLink Tx operates on a low power frequency that does not require you to obtain an
FCC license.
Product # 7617
I NSTALLING C ONSOLE L INK T RANSMITTER
The ConsoleLink Tx consists of a single module. (Refer to drawing 1A)
Attaching the ConsoleLink Tx to the Host Station
The transmitter has a short cable with modular connector on its free end. Insert
this plug into your weather station in the jack marked "WeatherLink". The unit
sits in the console base as shown.
Range
The range of radio transmission depends on several factors. Try to position the
DavisTalk compatible receiver(s) as close to the ConsoleLink Tx as possible.
Typical maximum ranges:
✦ Line of sight: 800 feet (240 m)
✦ Through walls and ceilings: 100 to 400 feet (30 to 120 m)
✦ Through trees and foliage: 100 to 400 feet (30 to 120 m)
Setting the ID Code
The ConsoleLink Tx may be set to use any of eight selectable ID codes (the
default is ID Code #1). The transmitter and receiver will only communicate
with each other if they are both set to the same ID code. Use the default setting
unless you have another Davis wireless system operating nearby which you
want to work separately from the new system. The dip switch settings for the
eight possible codes are shown below.
ID CODE
DIP SWITCH 1
DIP SWITCH 2
DIP SWITCH 3
#1 (default)
#2
#3
#4
#5
#6
#7
#8
off
off
off
off
ON
ON
ON
ON
off
off
ON
ON
off
off
ON
ON
off
ON
off
ON
off
ON
off
ON
To change to another ID, toggle dip switches 1, 2, and/or 3 on the transmitter
to the desired code. Remember that the transmitter and receiver must use the
same ID code in order to communicate so if you change the ID code on the
transmitter, you must change the ID Code on the receiver to match.
Note: Dip switch #4 is used for testing and warnings, not for ID codes (see “Test Mode” on page 3).
Page 2
ConsoleLink
Powering Up the ConsoleLink Tx
To power up the ConsoleLink Tx, apply power to your host weather station. If
the ConsoleLink Tx is working properly, it will make a single or double beep
about 30 seconds after the weather station is energized. The single beep indicates that the unit is working properly and that no WeatheLink data logger is
connected to the unit. Two beeps indicate that the unit is working properly and
that a WeatheLink data logger is connected to the unit.
Test Mode
To verify that the ConsoleLink Tx transmitting data, a test mode is provided.
In this mode the beeper beeps each time the unit transmits data (2.5 second
interval).
Using a WeatherLink Data Logger
Install the ConsoleLink Tx as instructed above. Plug the short (3", 75mm) modular connector from the WeatherLink into the ConsoleLink Tx as shown in
drawing 4. Alternately, use the optional 8 ft. extension cable and coupler to
make the connection.
T ROUBLESHOOTING
While the ConsoleLink Transmitter is designed to provide years of trouble-free
operation, occasional problems may arise. If you experience a problem, please
check the troubleshooters listed below before calling the factory. If you still are
unable to solve the problem, call the factory at (510) 732-7814 for assistance.
Please do not return your unit for repair without prior authorization.
✦ Console is receiving erratic data
Enable the Test Mode on the transmitter. If two beeps or more are heard in
a 2.5-second interval, then another Davis wireless system may be operating
nearby on the same ID, or a cordless phone may be operating within 10 feet
of the receiver. Either try changing to a different ID code on both the
receiver and the transmitter, or try moving the phone. Reapply power to
the console to activate the new ID code.
✦ Console is not receiving any data
The transmitter and the receiver may be too far apart, or something in their
path may be interfering, such as foliage, furnishings or cordless phones.
Enable Test Mode on the transmitter to see if it is receiving data. Try moving the receiver closer to the transmitter or vice versa; or eliminating possible path interferences.
Troubleshooting
Page 3
S PECIFICATIONS
✦ Transmit frequency - 916.5 MHz
✦ ID codes - 8 user selectable
✦ License - Low power no license required
✦ Temperature range - 0 to 60 °C
FCC P ART 15 C LASS B R EGISTRATION W ARNING
This equipment has been tested and found to comply with the limits for a class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
✦ Reorient or relocate the receiving antenna.
✦ Increase the separation between the equipment and receiver.
✦ Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
✦ Consult the dealer or an experienced radio/TV technician for help.
Shielded cables and I/O cords must be used for this equipment to comply with
the relevant FCC regulations. Changes or modifications not expressly
approved in writing by Davis Instruments may void the user's authority to
operate this equipment.
Product Number: 7617
Davis Instruments Part Number: 7395-067
ConsoleLink Installation Manual
Rev. A Manual (8/5/99)
Controlled Online: Weather Manuals:DavisTalk:ConsoleLink
© 1999 Davis Instruments Corp. All rights reserved.
3465 Diablo Avenue, Hayward, CA 94545-2778
510-732-9229 • Fax: 510-732-9118
E-mail: info@davisnet.com • www.davisnet.com

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Create Date                     : 1999:08:05 11:44:45
Producer                        : Acrobat Distiller 3.01 for Power Macintosh
Author                          : 
Title                           : ConsoleLink for FCC
Creator                         : FrameMaker 5.5.3
Modify Date                     : 1999:08:23 17:15:33-07:00
Page Count                      : 4
Page Mode                       : UseOutlines

EXIF Metadata provided by EXIF.tools