DawnSun Electronic Technology ZhongShan TX005R Fan Remote Controler User Manual
DawnSun Electronic Technology.Co.,Ltd.ZhongShan Fan Remote Controler Users Manual
Manual
MODEL:TX005
TX005-R
OPERATION INSTRUCTION
Learning Code -With the main power on, press the
HI & LOW button on the transmitter at the same time
and hold for 5 seconds could achieve the learning code.
●
Remote Functions:
●
●
Light Source Auto-recognition Technique :Be able to recognize
incandescent and CFL automatically.
Switch Off Memory - when power is off and back again, resume
the status of both light and fan before switch off.
12V
Front
Back
1
2
3
12V
4
Back
TX005 TX005-R
:
,
◎
◎
:
.
1.Fan speed control button To control the
ceiling fan speed HIGH MEDIUM,LOW.
2.FAN/OFF button: Turn off the fan;
Press and hold for 5 seconds
to enter Light Delay Off mode.
3.LIGHT ON/OFF/DIMMER button To control light
on,off and dimmer
Note:Install the 12-volt battery(not included) to the remote control.
:
,
◎
◎
:
.
:.
1.Fan speed control button To control the
ceiling fan speed HIGH MEDIUM,LOW.
2.FAN/OFF button: Turn off the fan;
Press and hold for 5 seconds
to enter Light Delay Off mode.
3.LIGHT ON/OFF/DIMMER button To control light
on,off and dimmer
Reverse function button To control fan direction4.
OPERATION INSTRUCTION
●Products shall be subject to any changes without additional notices due
to DawnSun will keep innovation and optimization on the products.
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1)This device may not cause harmful interference
This device must accept any interference received including interference that may
cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment
.
.
,(2)
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and use in accordance with
the instructions, may cause harmful interference to radio communications.
However there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1.Reorient or relocate the receiving antenna.
2.Increase the separation between the equipment and receiver.
3.Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
4.Consult the dealer or an experienced radio/TV technician for help.
,