Dayton PRSBLE 2.4GHz BLE Proximity Key Fob User Manual PRSBLE x
Dayton Industrial Co., Ltd. 2.4GHz BLE Proximity Key Fob PRSBLE x
Dayton >
Exhibit 08 Users Manual
BLE Proximity key fob
User manual
- Proximity sensor allows you to tag and keep track of belongings electronically
using your Bluetooth-SMART enabled phone
- Tag transmits signal up to 100ft.
- Compatible with iOS and BTLE Smart Phones
- Water-resistant
- Replaceable 3Volt CR2025 coin cell battery
-
To power on:
Press and hold button for approximately 7 seconds. One beep
followed by two short beeps and red LED will indicate you have successfully
powered on.
-
To power off:
Press and hold button for 2 seconds. One short beep will
indicate you have successfully powered off.
-
Removing battery:
Open battery compartment. Replace battery with a
CR2025 3 Volt. Note: Wait approximately 45 seconds before installing the new
battery to ensure the electronics fully reset.
FCC Rules Part 15
The enclosed hardware device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference and
(2) It must accept any interference received, including interference that may cause
undesired operation.
FCC ID: O4GPRSBLE
IC: 7666A-PRSBLE
FCC Compliance Statement:
This equipment has been tested and found to comply with limits for a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in residential
installations. This equipment generates, uses, and can radiate radio frequency energy,
and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause interference to radio or television equipment reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna
-Increase the separation between the equipment and receiver
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
To assure continued compliance, any changes or responsible for compliance could
void the users authority to operate this equipment. (Example- use
only shielded interface cables when connecting to a computer or peripheral devices).
Radiation Exposure Statement
This device complies with Part 15 of the FCC Rules. Operation is subjected to the
following two conditions 1) this device may not cause harmful interference and 2) this
device must accept any interference received, including interference that may cause
undesired operation.
Caution! The manufacturer is not responsible for any radio or TV interference caused
by unauthorized could void the users authority to operate the equipment.
IC Statement
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device. The device meets the exemption
from the routine evaluation limits in section 2.5 of RSS 102 and users can obtain
Canadian information on RF exposure and compliance.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes: (1) I’appareil ne doit pas produire de brouillage, et (2) I’utilisateur de
I’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement. Le dispositif rencontre I’exemption
des limites courantes d’évaluation dans la section 2.5 de RSS 102 et les utilisateurs
peuvent obtenir I’information canadienne sur I’exposition et la conformité de rf.