Dcs Computer Hardware 974 Users Manual 124112ma1A1
2015-02-02
: Dcs Dcs-Dcs-Computer-Hardware-Dcs-974-Users-Manual-425569 dcs-dcs-computer-hardware-dcs-974-users-manual-425569 dcs pdf
Open the PDF directly: View PDF
Page Count: 131 [warning: Documents this large are best viewed by clicking the View PDF Link!]
- Product Overview
- Contents
- Step-by-Step Guide
- Typical Applications
- Converting a 24/96 recording to CD format
- Demultiplexing a 24/96 Dual AES recording (Bit for Bit)
- Upsampling a CD
- General Sample Rate Conversion and Distribution
- PCM to DSD
- Using a Master Clock
- Converting Quad AES to CD Format
- Multi-channel Sample Rate Conversion – bit aligned sources
- Multi-channel Sample Rate Conversion – Using a Master Clock
- Multi-channel Sample Rate Conversion – with more alignment tolerance
- Multi-channel Sample Rate Conversion – with multiple sample rates out
- The Software – Menu and Setups
- The Hardware – Controls and Connectors
- Rear Panel
- Signal Inputs
- AES/EBU Digital Inputs 3 pin XLR Female (4 off – AES 1 – AES 4)
- AES/EBU Reference Loop 3 pin XLR Female / Male (AES Ref Loop IN & OUT)
- Sync Input BNC
- SPDIF Inputs Various (3 off – RCA IN, BNC IN, TOS IN)
- DSD/SDIF Input BNC (4 off – CH1 IN, CH2 IN, WCLK IN, LOOP OUT)
- Signal Outputs
- AES/EBU Digital Outputs 3 pin XLR Male (4 off – AES 1, AES 2, AES 3, AES 4)
- AES/EBU Clock Output 3 pin XLR Male (1 off – AES CLK OUT)
- SPDIF Outputs Various (3 off - RCA OUT, BNC OUT, TOS OUT)
- DSD/SDIF Output BNC (3 off – CH1 OUT, CH2 OUT, WCLK OUT)
- Control and Power
- Remote 9 pin D type Female (2 off, Remote In and Loop Out)
- Mains Supply 3 pin IEC (CEE22)
- Additional Information
- Front Panel
- Rear Panel
- dCS 974 Technical Information
- dCS 974 Performance Curves
- General Technical Information
- Using Your dCS 974 For The First Time
- Options
- Maintenance and Support
- Troubleshooting
- FAQs
- The unit fails to lock to a source signal.
- The unit locks but no signal is received.
- The destination device fails to lock to the unit.
- The destination device locks but no signal or just noise is received.
- The destination device connected to the AES or SPDIF outputs reports an error.
- Output audio quality is poor.
- Output audio bandwidth is low.
- A stereo output signal is expected but signal is present on one channel only.
- A stereo output signal is expected but one channel of the input appears on both channels of the output.
- Tone appears on the outputs.
- The LCD display is unreadable but the Power LED and possibly some other LEDs are lit.
- Strange characters appear on the LCD display.
- The stereo image is poor or out of position.
- Maximise fails to increase the signal level to full scale.
- “Invalid Fs Out for Fs In” message.
- The Customise Display menu will not allow another option to be set.
- If You Need More Help
- Other Information
- FAQs
- Indexes and Software Version Numbers