Delta Electronics orporated VFRU-25-26BT Bluetooth Speaker User Manual Manual

Delta Electronics Incorporated Bluetooth Speaker Manual

Manual

VFRU-25-26BT 使用說明 A. Turn on  Plug the included USB cable into the DC IN jack on the side of the speaker Plug the other end of the USB charging cable into 5VDC power source, the power up tone sounds and the button starts blinking  Press the button on the top of the speaker, the button starts blinking B. BT Play Music Step1: Pairing mode Make sure the button is blinking rapidly in the pairing mode. Step2: Pair + Connect 1. Enable Bluetooth on your smartphone or other device and choose
DeltaBreez SIG from the pairing options on your smartphone. 2. The speaker gives an audio signal when it’s finished pairing and connecting to your smartphone. The button turns solid blue 3. To give one press to the button be Pause and press button again be Play. Step3: Disconnect If disable Bluetooth on your smartphone or other device, the button is blinking. If you want to pair to a new device, give a short double-press to the button. The speaker gives a signal and the button starts blinking. C. Aux in Play Music Step1: Aux in mode Use a 3.5mm audio cable (not include) to connect the audio output from your device to the AUX IN audio input on the speaker’s side panel.
Step2: Aux in input The speaker automatically switches to the AUX IN audio, and the button turns white. D. Reconnect If you’ve previously paired your phone or other Bluetooth device with this speker, the speaker will automatically attempt to reconnect to that device when you switch the speaker on. Unplug the cable from the speaker’s AUX IN jack. The speaker will try to reconnect to the last Bluetooth device. E: Turn off Press and hold the button. The power and the will be turn off Unplug the cable from the speaker’s AUX IN jack the power and will be turn off FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Navigation menu