Delta Tau Geo Macro Drive Users Manual User
2015-07-14
: Delta-Tau Delta-Tau-Geo-Macro-Drive-Users-Manual-773824 delta-tau-geo-macro-drive-users-manual-773824 delta-tau pdf
Open the PDF directly: View PDF
Page Count: 205 [warning: Documents this large are best viewed by clicking the View PDF Link!]
- Peak Torque
- Continuous Torque
- Wire Sizes
- Fuse and Circuit Breaker Selection
- Use of GFI Breakers
- Transformer and Filter Sizing
- Noise Problems
- Operating Temperature
- Single Phase Operation
- J1: AC Input Connector Pinout
- Earth Grounding Paths
- J4: 24VDC Input Logic Supply Connector
- Kinetic Energy
- Energy Lost in Transformation
- Capacitive Stored Energy in the Drive
- Evaluating the Need for a Regen Resistor
- Regen Resistor Power Capacity
- Hardware Setup
- Hardware Setup
- Hardware Setup
- Hardware Setup
- Hardware Setup
- Hardware Setup
- Hardware Setup
- Hardware Setup
- MACRO ASCII Communication global commands
- Absolute Phase Power-On Position Address and Format: Ixx81, Ixx91, Ixx75
- Absolute Servo Power-On Position Address and Format: Ixx10, Ixx95
- Current Loop Six-Step Procedure
- Turbo Software Setup (Turbo PMAC2 Ultralite, UMAC, and QMAC)
- Position Compare Port Driver IC
- X10 – MACRO Output Connector
- X11 – Input Connector
- Geo MACRO Drive Example for Absolute Position Data
- CONKIT1A
- CONKIT1C
- CONKIT2A
- CONKIT2C
- CONKIT4A
- Channel #1 Flags
- Channel #2 Flags
- General Purpose Inputs 1-4
- General Purpose Outputs 1-4
- Analog Input 1
- Analog Input 2