Denso Wave orporated DWBT002 Bluetooth Transmitter Module User Manual 442647
Denso Wave Incorporated Bluetooth Transmitter Module 442647
Users Manual
Operation manual
DWBT002 is installed in the handy scanner, so DWBT002 has no manual for user.
The operation method of DWBT002 is described by the user manual of a handy scanner (that is, GT10 B-SB of
DENSO WAVE).
1. Bar code data transmission to the host computer using communication equipment
(1) Registration of handy scanner and selection of the handy scanner
Transmits the registration signal from handy scanner and register the handy scanner at the
communication equipment.
Transmits the selection signal from communication equipment to the handy scanner and connect
communication equipment with the handy scanner.
(2) Bar code reading and data transfer
Handy scanner reads the bar code and transmits the reading data to communication equipment.
Communication equipment transmits the bar code data that carried out the receipt to a host computer.
2. Data communications with the personal computer equipped with radio.
(1) Registration of Bar code handy scanner and selection of the Bar code handy scanner
Transmits the registration signal from Bar code handy scanner and register the handy scanner at the
personal computer.
Transmits the selection signal from personal computer to the handy scanner and connect personal
computer with the handy scanner.
(2) Bar code reading and data transfer
Handy scanner reads the bar code and transmits the reading data to personal computer. Personal
computer calculates the received bar code data.
Bar code label
Bar code Label
User’s Manual Requirement of FCC rule
DWBT002 is installed in the handy scanner, so DWBT002 has no manual for user.
FCC user’s manual requirements that are FCC rule Part 15.21 and 15.105 are described on
user’s manual of the handy scanner (i.e. DENSO WAVE’s GT10B-SB).
Fig 6.2. FCC rule requirement for user’s manual
FCC and RSS-210 Regulations
This device complies with Part 15of the FCC Rules and RSS-210 Rules
Operation is subject to the following two conditions :
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
FCC WARNING : Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution : Radio Frequency Exposure
This device meets the FCC RF Exposure Guidelines in OET65.
This transmitter and its antenna should not be placed next to other antennas or similar radiating structure.
ICES-003 Regulation
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.