220 Ladder Mesh Joint Reinforcement 08220LAPRITEL
User Manual: 220
Open the PDF directly: View PDF 
.
Page Count: 1
HOHMANN & BARNARD, Inc.
30 Rasons Court | Hauppauge, NY 11788
CORPORATE HEADQUARTERS
T: 800.645.0616 F: 631.234.0683
www.h-b.com
Branch/Subsidiary Locations:
ALABAMA - ILLINOIS - MARYLAND
NEW YORK - PENNSYLVANIA - TEXAS
UTAH - CANADA
© HOHMANN & BARNARD, INC. - 2015
IMPORTANT: Since each construction project is unique, the appropriate selection
and use of any product contained herein must be determined by competent
architects, engineers and other appropriate professionals who are familiar with the
specific requirements of the project in question.
Finishes:
Mill Galvanized Coating
Hot-Dip Galvanized
Stainless Steel - Type 304
Stainless Steel - Type 316
Note: H&B recommends Stainless Steel for maximum protection
against corrosion.
Wire Size (10’ length standard, custom length available special order):
(S) Standard Weight:
9 Gauge Side Rods x 9 Gauge Cross Rods
(EH) Extra Heavy:
3/16” Side Rods x 9 Gauge Cross Rods
(SHD) Super Heavy Duty:
3/16” Side Rods x 3/16” Cross Rods
Block Size:
4" 6" 8" 10"
12" 14" 16"
Note: For Corner or Tee, state width of block walls.
DRAWINGS FOR ILLUSTRATIVE PURPOSES ONLY
Lox♦All® Ladder Joint Reinforcement
220 Ladder-Mesh
MATERIAL CONFORMANCE
Hohmann & Barnard joint reinforcement products conform to:
ASTM A951/A951M (Standard Specification for Steel Wire for Masonry
Joint Reinforcement)
ACI / ASCE 530 (Building Code Requirements for Masonry Structures)
Wire (Carbon Steel): Prefabricated from cold-drawn steel wire
conforming to ASTM A1064/A1064M
Tensile Strength - 80,000 p.s.i. | Yield Point - 70,000 p.s.i. minimum
Zinc Coating:
Mill Galvanized coating: ASTM A641/A641M (0.1 oz/ft²)
Hot-Dip Galvanized after fabrication: ASTM A153/A153M-B2 (1.5 oz/ft²)
Wire (Stainless Steel): ASTM A580/ASTM 580M - AISI Type 304 or
Type 316
Wire Diameter:
9 gauge (.148” or W1.7) or 3/16”Ø (.187” or W2.8)
Side Rods and Cross Rods available in any combination of the above.
Cross welded 16” O.C.
First Cross Rods welded 12” in from each end to allow lap splices per
code requirements.
H&B manufactures steel wire products from a minimum of 95%
recycled material.
PRINT FORM
RESET FORM
SAVE FORM
SAVE FORM LOCK & HIDE BUTTONS
