Edelbrock 3501 Fuel Injection System Installation Instructions Performer Multipoint 3502 350

User Manual: Performer Multipoint 3502

Open the PDF directly: View PDF .
Page Count: 1

APPENDIX A

PERFORMER MULTIPOINT EFI SYSTEM

Catalog #3501/3502

Throttle Bracket Modifications for Vacuum Diaphragm

Cruise Control Systems (early body style trucks)

Suggested Tools and Materials:

• Drill motor & 9/32” bit

• Hack Saw

• ¼-20 bolt, nut & lock

washer.

Step 1) Using the guideline on the

following page, cut your Edelbrock

bracket with hacksaw along specified

line and drill Ø9/32 hole.

Step 2) A 1.0” portion of the rib

must be flattened as shown below.

Step 3) The OEM bracket must be

cut as shown below. Discard the

piece on the right side of the photo.

Step 4) Loosely assemble the OEM

and Edelbrock brackets as shown

below. Some minor adjustments

may be required once assembly is

bolted on to engine.

Step 5) Install bracket assembly onto

engine. Check for contact between

the vacuum actuator boot and the

throttle bracket. If contact exists

remove more material from the cut

line until full clearance is obtained.

Tighten all bolts on assembly.