Preloaded Coated Filters Cat. No. 225 9027 Operating Instructions Form 40110 PDF
User Manual: 40110
Open the PDF directly: View PDF .
Page Count: 1
Preloaded Coated Filters
Cat. No. 225-9027
SKC coated fi lters are shipped preloaded in the cassettes with end plugs and
shrink bands in place. No assembly is required; they are ready to use.
Method & Chemical:
OSHA PV2055 for 1,3,5-triglycidyl isocyanurate (TGI)
Filter & Coating: Glass fi ber fi lter coated with hydrobromic acid and cellulose
pad. Two-piece 37-mm cassette. Closed-face sampling confi guration
Prior to Sampling: Store at ≤ 39.2 F (4 C) for up to 6 months.
Sample Stability: Store samples at ≤ 39.2 F (4 C) for up to 7 days.
For information on other available
coated fi lters, request SKC Publication 1219.
Operating Instructions
863 Valley View Road, Eighty Four, PA 15330
Tel: 724-941-9701 • www.skcinc.com
How to Use the SKC Preloaded Coated Filters
Ensure that fi lter cassettes are at room temperature before sampling.
1. Select one coated fi lter cassette for calibrating the fl ow rate. A red plug
secures the inlet, which is clearly marked “inlet,” and a blue plug secures the
outlet. Set up the sampling train for calibration with the representative fi lter
cassette in line. For “closed-face” sampling, remove the plugs and connect the
cassette to the sampling train. For “open-face” sampling, remove the outlet
plug and the cassette inlet section and then connect the cassette to the sampling
train. For details on setting up a sampling train, refer to the SKC Sample Setup
Guide “Sampling Train - Filters” (SKC Publication 1922).
2. Calibrate the pump to the desired fl ow rate using a calibrator.
3. Replace the cassette used for calibration with a fresh coated fi lter cassette
for sample collection. Attach the cassette to a worker’s collar, as close to the
breathing zone as possible, by using a fi lter cassette holder (SKC Cat. No.
225-1). Sample for the specifi ed time interval and record the time.
4. Remove the fi lter cassette at the end of the specifi ed sampling period and
replace both end plugs (and the inlet if necessary). Recheck the fl ow rate using
the same cassette and calibrator used for calibration (in Step 2) to ensure that
the fl ow rate has not changed by more than 5%.
5. Store samples at ≤ 39.2 F (4 C) for up to 7 days. Appropriately package
samples, blanks, and all pertinent data to send to a lab for analysis. Expedite
shipping of samples to laboratory. Friday shipments are not recommended.
Form 40110 Rev 1710
SKC Limited Warranty and Return Policy
SKC products are subject to the SKC Limited Warranty and Return Policy, which
provides SKC's sole liability and the buyer's exclusive remedy. To view the complete
SKC Limited Warranty and Return Policy, go to http://www.skcinc.com/warranty.asp.