CM6T Manual Web

User Manual:

Open the PDF directly: View PDF PDF.
Page Count: 2

DownloadCM6T Manual Web
Open PDF In BrowserView PDF
CM6T built-in loudspeaker

CM6T

The Apart CM6T is a 2-way 100V/70V/16 ohm built-in ceiling loudspeaker. The loudspeaker has
a 6½” woofer, a 1” coaxial tweeter and a high quality 100/70 volt speaker line transformer with
multiple power taps. It’s the perfect choice for the distribution of microphone calls and background
music. The mounting frame is made of high quality ABS. The grille is made of aluminium.
Safety precaution
•
•
•
•
•
•
•
•
•
•
•
•

Keep this manual for future reference.
When cutting the mounting hole for the speaker, make sure there is sufficient clearance behind the
panel (no obstructions like A/C channels, power lines etc).
Take care of your speaker wires, they should be free of damage. Damaged speaker wires might result in
poor sound quality and can damage amplifiers.
Only use accessories specified by the manufacturer
Make sure the mounting panel can support the speakers weight.
Use sufficient amount of speakers to avoid dead spots.
No mains power shall be connected to the loudspeakers, doing so will damage the speaker.
This apparatus should only be serviced by qualified personnel. If not warranty might be void.
Use cable of the right gauge, certainly for long runs.
Use cables with clear color indication and maintain polarity throughout the whole system.
Avoid loud feedback from microphones, this can damage your speaker.
Please check the units condition after unpacking. If the outside of the carton box has been damaged,
inform your shipper immediately.

Warranty info
Warranty claims and claims for hidden defects can
be considered only if the defects appear within the
warranty period of 24 months and are notified within
8 days following their appearance per registered letter.
The warranty is not valid in case of an incident, wear,
for moving parts, power surges, inadequate packing

or shipping, improper use or storage and the disregard
of recommendations of Audioprof. The warranty only
concerns the spare parts and not the involved labor,
transportation or any other costs. The product must
be returned in the original packaging with the proof
of purchase by an Audioprof authorized reseller.

The general terms and conditions can be found here:
http://www.apart-audio.com/conditions/General_Terms_and_Conditions_Audioprof.pdf
WWW.APART-AUDIO.COM

Mounting the loudspeaker

1
The loudspeaker is easy to install, due to its simple mounting system.
(1) Use the cutout template to mark the mounting hole.
(2) When making the hole in your mounting panel, double check if there are no cables
or any other obstructions behind the mounting panel. Cutting the mounting panel
without this check might result in damaged infrastructure or power lines. Please make
sure that the mounting structure is capable of safely supporting the speaker’s weight.
(3) R
 emove the speaker grille: turn the mounting clamps (dog-ears) outwards and push
them in the direction of the grille until it pops out. Remove the grille.
(4) Turn the dog-ears inwards again and tighten the dog-ear screws slightly to make them
stay in the inward position.

2

(5) Connect the speaker wires and (6) insert the speaker in the precut speaker opening.
(7) 
Fasten the dog-ear screws carefully until the speaker sits safely in place. Do not
overtighten the dog-ear screws!
(8) Carefully push the grille back in place.
NOTE: for use in low impedance systems, always disconnect the 100/70 volt
transformer and connect the low impedance speaker wires directly at the speaker.

3

4

5
100V / 70V

low impedance

6

7

8

outside diameter

205 mm

low impedance dynamic power

depth

75 mm

SPL 1W/1m

87 dB

cutout

186 mm

max SPL 1m

105 dB

60 watts

loudspeaker system

2-way

frequency response

60 - 20 kHz

woofer size

6.5 inch

main construction material

ABS plastic

woofer cone material

polypropylene

grille main material

aluminium

tweeter size

1 inch

IP rating

54

mounting system

3 screws

applicable low impedance

yes

100/70V* power taps

6 - 3 - 1.5 – 0.75* watts

applicable in 100V / 70V

yes

impedance

16 ohms

dispersion angle 1000 Hz

180°

*0.75 W: 70 volt only

WWW.APART-AUDIO.COM
Source Exif Data: 
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.7
Linearized                      : Yes
XMP Toolkit                     : Adobe XMP Core 5.3-c011 66.145661, 2012/02/06-14:56:27
Create Date                     : 2015:03:05 11:51:10+01:00
Metadata Date                   : 2015:03:05 11:51:21+01:00
Modify Date                     : 2015:03:05 11:51:21+01:00
Creator Tool                    : Adobe InDesign CS6 (Macintosh)
Instance ID                     : uuid:c5d5ce6c-974f-0448-a37c-64572286f749
Original Document ID            : xmp.did:ED7F11740720681197A5EA677B3C9262
Document ID                     : xmp.id:365E166A232068118C14F34D8E945D59
Rendition Class                 : proof:pdf
History Action                  : converted
History Parameters              : from application/x-indesign to application/pdf
History Software Agent          : Adobe InDesign CS6 (Macintosh)
History Changed                 : /
History When                    : 2015:03:05 11:51:10+01:00
Derived From Instance ID        : xmp.iid:7D33039B202068118C14F34D8E945D59
Derived From Document ID        : xmp.did:ED7F11740720681197A5EA677B3C9262
Derived From Original Document ID: xmp.did:ED7F11740720681197A5EA677B3C9262
Derived From Rendition Class    : default
Format                          : application/pdf
Producer                        : Adobe PDF Library 10.0.1
Trapped                         : False
Page Count                      : 2
Creator                         : Adobe InDesign CS6 (Macintosh)
EXIF Metadata provided by EXIF.tools

Navigation menu