CY8CKIT 049 4xxx PSoC® 4 Prototyping Kit Guide 059 PSo C 5LP Protoyping

• Contents
• Safety Information
  • Regulatory Compliance
  • General Safety Instructions
• 1. Introduction
  • 1.1 Kit Contents
  • 1.2 PSoC Creator
    • 1.2.1 PSoC Creator Code Examples
    • 1.2.2 Kit Code Examples
    • 1.2.3 PSoC Creator Help
    • 1.2.4 Component Datasheets
  • 1.3 Getting Started
  • 1.4 Additional Learning Resources
  • 1.5 Technical Support
  • 1.6 Document Conventions
• 2. Software Installation
  • 2.1 Before You Begin
  • 2.2 Install Software
  • 2.3 Uninstall Software
• 3. Kit Operation
  • 3.1 Theory of Operation
  • 3.2 KitProg
  • 3.3 Programming and Debugging the PSoC 5LP Target Device
    • 3.3.1 Programming using PSoC Creator
    • 3.3.2 Debugging using PSoC Creator
    • 3.3.3 Programming using PSoC Programmer
  • 3.4 USB-UART Bridge
  • 3.5 USB-I2C Bridge
  • 3.6 Updating the KitProg Firmware
• 4. Hardware
  • 4.1 Board Details
  • 4.2 Hardware Details
    • 4.2.1 Target Board
    • 4.2.2 KitProg Board
    • 4.2.3 Power Supply System
      • 4.2.3.1 Measure PSoC 5LP Current Consumption
    • 4.2.4 Board Separation (Snapping)
    • 4.2.5 Header Connections
      • 4.2.5.1 Functionality of the J1 and J2 Headers (Target Board)
      • 4.2.5.2 Functionality of J7 and J3 Headers (PSoC 5LP to KitProg)
      • 4.2.5.3 Functionality of J8 and J9 Headers (KitProg)
    • 4.2.6 User and Passive Inputs
      • 4.2.6.1 Push Button
      • 4.2.6.2 Reset/Boot Button
      • 4.2.6.3 LEDs
      • 4.2.6.4 System Capacitors
• 5. Code Examples
  • 5.1 Using the Kit Code Examples
  • 5.2 CE95352 Blinking LED
  • 5.3 CE95277 ADC and UART
  • 5.4 CE95394 USB HID Mouse
• A. Appendix
  • A.1 PSoC 5LP Prototyping Kit Schematics
  • A.2 Programming PSoC 5LP Prototyping Kit Using MiniProg3/KitProg
  • A.3 Bill of Materials
• Revision History
  • CY8CKIT-059 PSoC® 5LP Prototyping Kit Guide Revision History