IIDL1_J30C DL1 Door Control Timer

User Manual: DL1 Door Control Timer AlarmHow.net Library

Open the PDF directly: View PDF .
Page Count: 1

DL1 - Door Control Timer

Specifications:

•12 volt - 24 volt AC or DC operation.

• Dry relay output (1 form “C” contact, rated @ 2 amp).

• Isolated AC or DC voltage 3V-24V trigger.

• Time adjustable from 1 second to 1 minute.

•12VDC regulated beeper output.

•Momentary or maintained trigger.

Board dimensions (approximate): 4"L x 1.5"W x .75"H

Installation Instructions:

1. Unit operates from 12-24 volts AC or DC. Voltage source should be connected to the terminals marked [AC].

When using DC power, polarity does not have to be observed.

2. Use form [C] relay contacts to operate desired device (magnetic lock, door strike, etc.). During normal

operation [C] contact is connected to [NC] and transfers to [NO] when timing cycle is initiated.

3. Adjust desirable time. By turning timing potentiometer clockwise you increase duration of the output.

4. Connect trigger voltage source to both terminals marked [TRG].

5. A surge suppressor should be used to eliminate RMI that is generated when electrical coil is being powered

down. It is recommended to use a diode in parallel with every DC coil magnet,

(Banded end of diode connected to positive terminal of coil or magnet).

DL1_S

DOOR TIMER

ALTRONIX CORP.

BKLYN, NY 11220

MADE IN USA

AC NO NC C- BEEP +

TRG

AC

Altronix is not responsible for any typographical errors.

140 58th Street, Brooklyn, New York 11220 USA, 718-567-8181, fax: 718-567-9056

website: www.altronix.com, e-mail: info@altronix.com, Lifetime Warranty, Made in U.S.A.

IIDL1 - Rev. 110601 J30C MEMBER