F 135 User Manual

• F-135
• F-135 Plus
• User Manual
• Scanner Specifications
  • Minimum Host Computer Specifications
  • Power
  • Contents of Box
  • Size
  • Resolutions
  • Light Source
  • Film Types and Variations
  • DX Code Reading
• Installing the F-135
  • 1. Install the software for the F-135, if it is not already installed on the PC.
  • 2. Clear a space near your computer system to place the F-135 scanner. The USB 2.0 cable must be able to reach the PC, so it cannot be more than 6 feet (2m) from the computer.
  • 3. Connect the power cord to the power supply plug on the back of the scanner.
  • 4. Connect the USB 2.0 cable to the back of the scanner.
  • 5. Connect the USB 2.0 cable to the back of the computer, in a USB 2.0 port. Do not plug in to a USB 1.0 connector!
  • 6. While the computer is on and Windows is loaded, turn the scanner power switch into the ‘on’ position.
  • 7. Windows will prompt you to click “Next” to continue the driver installation.
  • 8. Then click on “Finish” to finish the driver installation.
  • 9. The process will repeat twice before finishing.
  • 10. After the driver is finished installing, verify that the scanner driver is properly installed, by viewing the scanner properties in the Device Manager under the heading, “Imaging Devices.”
  • 11. Clean the F-135 from any dust that may be inside the scanner. Please refer to these procedures in the “Operator Maintenance” chapter.
  • BIOS Configuration
• Operational Information
  • Powering On
  • Operation and Film Insertion
    • Calibration
  • LED Indicator Lights
  • Digital ICE
• Operator Maintenance
  • Cleaning the Film Track
    • 1. Position the tip of the compressed air hose in the film track entrance, and blow, moving the hose up and down while blowing inside.
    • 2. Follow the cleaning instructions for cleaning the scanner cover below.
    • 3. After cleaning the film track, run the ‘Film Track Test’ in the client interface program.
  • Cleaning the Scanner Cover
    • 1. Aim the hose of a can of compressed air into the film path--blowing the air away from the film entrance.
    • 2. On the film exit side, blow the air away from the film exit.
• Service Policy
  • Warranty Period - New Equipment
  • Warranty Service - New Equipment
  • Warranty Service - Refurbished/used Equipment
  • After Warranty Service / OEM Service
  • Software
• Warranty
• Contacting Technical Support
  • When contacting support by phone, please follow these guidelines to ensure timely assistance:
  • If you prefer to email support, please include the following information in your email request:
  • Pakon Contact Information
    • Phone:
    • Email:
    • On the Web:
• Regulatory Information
  • Warning:
  • Note:
  • Site Conditions: