FAXABLE FMR500 FRM 500, HM WT 500

FMR-500 FMR-500

FMR500_Specifications

User Manual: FRM-500, HM-500, WT-500

Open the PDF directly: View PDF PDF.
Page Count: 2

FMR-500 UHF
WIRELESS MICROPHONE SYSTEM
Power,
Performance,
Flexibility, and
Simplicity.
CRYSTAL
8
FREQUENCY
3
4
VHF
1112
10
+
AGILE
FREQUENCIES
CRYSTAL
8
FREQUENCY
3
4
VHF
1112
10
+
AGILE
FREQUENCIES
CRYSTAL
8
FREQUENCY
3
4
VHF
1112
10
+
AGILE
FREQUENCIES
CRYSTAL
8
FREQUENCY
3
4
VHF
1112
10
+
AGILE
FREQUENCIES
The FMR-500 brings professional features and performance to the small
and medium sized wireless microphone installs that are so popular
today. One touch Auto ClearScan™selects the clearest channel in the
clearest group of compatible channels in just seconds with
the push of one button. The new HT-500 programmable handheld
microphone transmitter is the smallest Telex has ever built and it has a
screw-on battery cover that also hides the controls, and an
LCD display. Choose the EV®N/D 767a dynamic microphone or the
EV RE410 condenser microphone for high quality vocal per formance.
The WT-500 bodypack transmitter features a cell phone style beltclip,
dual latching battery door, and a TA4 connector with a wide variety of
lapel and headworn microphone options. The combination of sound and
RF features are hard to beat at twice the price.
Key Features
• Up to 10 systems can operate
simultaneously from the pre-set groups of
channels in one operating band. Groups
of 16 coordinated channels between the
two bands are also pre-set.
• Advanced ClearScan™and one touch Auto
ClearScan automatic group and channel
selections, for quick and easy system
setup.
• Completely programmable in 25kHz steps
across 28MHz for 1112
possible frequencies
• Backlit receiver LCD display shows the
Group/Channel, Frequency, transmitter
battery status, diversity operation,
and RF and Audio level meters.
• Balanced XLR audio output for Microphone
or Line level signals and
a 1/4 inch line level jack to match
any application.
• Fourth generation Posi-Phase™diversity and
advanced audio circuits provide maximum
range and professional
sound quality.
• Includes single and dual rack mount
hardware with front mount antenna cables.
• “Smart” battery circuit means there
is no way to put the battery in wrong.
• Tone Code plus Amplitude squelch
with one button on/off.
• Three year warranty.
SPECIFICATIONS
TELEX®FMR500 UHF WIRELESS MICROPHONE SYSTEM
TELEX COMMUNICATIONS
12000 Portland Avenue South, Burnsville, Minnesota 55337 U.S.A.
TEL: 800-392-3497 • FAX: 952-736-4582
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
©2003 Telex Communications PA20636 9/03
e
pro.sound@telex.com
w
www.electrovoice.com/telex-wireless
FMR-500 Receiver Transmitters WT-500 and HT-500
FRONT PANEL
REAR PANEL
Receiver Type Synthesized PLL
Frequency Range (RF) A Band 648 – 676 MHz
B Band 696 – 724 MHz
Number of Channels 1112 possible frequencies
Programmable in 25 kHz steps
Modulation +/- 40 kHz
Diversity Digital Posi-Phase™ True Diversity
RF Sensitivity < 1.0 mV for 12 dB SINAD
Image Rejection > 60dB
Squelch Tone Code plus Amplitude
Ultimate Quieting > 100dB
FCC Certification Approved under Part 15
Power Requirements 12 V AC/DC 300mA
Operating Temperature -7° to 49° C (20° to 120° F)
Dimensions 1.72” H x 7.5” W x 5.9” D
43.69mm H x 190.50mm W x 150mm D
AUDIO PARAMETERS:
Frequency Response 50 – 15kHz +/- 2dB
Balanced Output (max @ 40kHz deviation)
Mic Position -10dBV
Line Position adjustable 10mV - 2V RMS
Unbalanced Output adjustable 10mV - 1V RMS
Distortion <1.0%, 0.5% typical (ref 1kHz, 40kHz deviation)
Signal-to-Noise Ratio >100dB A Weighted
Dynamic Range >100dB
Radiated Output 30 mW typical
Microphone Head ElectroVoice767a N/D 767a
supercardioid N/DYM Dynamic
Microphone Head ElectroVoice RE410 RE410 cardioid condenser
Standard Lavalier Microphone ELM-22S MicroMini™
Omni-Directional Condenser
TA4 Connector Wiring Pin 1: Ground; Pin 2 Mic Input;
Pin 3: +5V bias; Pin 4: +5V bias
through a 3k Ohm resistor
Audio Gain Adjustment 40 dB (26dB HT500)
Power Requirements 9 Volt Alkaline Batter y
Battery Life (Typical) > 8 hours with 9-Volt Alkaline Typical
Bodypack Antenna Flexible external 1/4 wave
Handheld Antenna Internal 1/2 wave
Dimensions (Handheld) 9.4 in. (24.0cm) Long
Dimensions (Bodypack) 3.8 in. H x 2.38 in. W x 0.92 in. D
96.5 mm H x 60.5 mm W x 23.4 mm D

Navigation menu