Finger Tip Cover Instructions
User Manual:
Open the PDF directly: View PDF 
.
Page Count: 5
PART: FINGER TIP COVER
INSTRUCTIONS
Start off by printing the mould found it the Files section.
Brush, wax or vaseline or dish soap on the parts of the mould. The best is wax. This will help to avoid
adherence of the silicone to the ABS or PLA.
Let the dish soap dry well before going to next step.
PART: FINGER TIP COVER
Use a clamp to assemble the mould together. There is two holes of 3mm to add pins if you want to
align the mould correctly. (Not shown on pictures)
You can use bathroom or windows silicone cartridge. Take something that dries fast. The cartridge
silicone cures with air and humidity, so it will take a while to cure correctly in the mould. The ideal is a
two component silicone because it cures with a hardener and can be accelerated up to a few minutes.
It is what I used, but for the tutorial I’m showing a cartridge.
Fill up to half each finger with the silicone. Then add and press firmly the third part of the mould,
ensure that you put it in the correct way. (Thumb in thumb…)
When you press the exceeding silicone should come out a little bit from everywhere, so don’t do this
on your bed or on grandma’s napkin.
Let the silicone cure. Some silicone might take a week to dry out.!
PART: FINGER TIP COVER
Depending of your silicone curation time, open the mould carefully with a small screwdriver.
Careful, the silicone is thin and can tear off easily, so be patient and handy.
You should have something like the picture above.
With scissors cut the silicone between each finger. This will help to roll it out from each finger. Again,
be careful, the silicone is thin and can tear off easily, so be patient and handy.
PART: FINGER TIP COVER
Now take your best scissors to cut out the silicone excess as close as possible to the edge, without
making a hole. Measure the length you want to cover with the silicone and cut it cleanly before
applying it on the finger. Remember there is a nail side.
That’s it your InMoov is ready to grab and pick up stuff.!
PART: FINGER TIP COVER
Things needed:
-The printed mould.
-Scissors.
-A clamp.
-Brush.
-Wax
-OR vaseline
-OR dish soap.
-Silicon in a cartridge for bathroom or windows.
-OR two component silicon like Trecosil RTV 6007 (it’s the one I used).
