INSTRUCTIONS_'NO HOLES'_MB 2010 S63 AMG INSTRUCTIONS GMG NOHOLES MB

User Manual: 2010 S63 AMG

Open the PDF directly: View PDF .
Page Count: 2

Page 1 of 2

‘NO HOLES’ License Plate Bracket Kit

Mercedes Benz

This kit allows the owner of any Mercedes Benz to attach a front license plate to their car

without the need to drill holes. Mercedes Benz has always attached the front license plate

by drilling the front bumper and permanently mounting the license bracket to the front

bumper with screws. The ‘NO HOLES’ kit mounts the front license plate utilizing the front

tow hook attachment point. The kit comes complete with all mounting hardware, including

the screws to affix the license plate to the bracket. The bracket allows for the mounting of

normal size US license plates and European style plates.

(WARNING: The bolt installed into the TOW HOOK attachment point is not to be

utilized as a tow hook bolt. It is designed to hold the license plate only.)

The ‘NO HOLES’ License Plate Bracket Kit contains:

Tow Hook Adapter Bolt (6) License Plate Bolts

License Plate Bracket (6) License Plate Washers

(1) 19mm Bolt (6) License Plates Lock Nuts

(2) Large Washer (2) Height Adjustment Brackets

(1) Large Lock Washer

Tools required for installation:

19mm Wrench or Socket w/Ratchet Adjustable Wrench

10mm Wrench 4mm Allen Wrench

Page 2 of 2

Installation Instructions:

1. Remove tow point access cover for the front tow hook mounting point located on

passenger side of the front bumper. Gently pull plastic retainer to remove cap from car.

Store cap in a safe place to reinstall later if desired.

2. Insert the ‘NO HOLES’ tow hook adapter bolt

into the tow point and tighten with the

adjustable wrench.

3. Install one or both of the flat washers onto the

‘NO HOLES’ mounting bolt after putting the

lock washer and bolt through the angled license

plate mounting bracket. While holding the

license plate bracket in a level position, tighten

the 19mm bolt until the bracket is secure.

4. At this point, install the Optional License Plate Height

Adjustment Brackets.

To install the license plate height adjusters, select the hole of the

desired height and insert the bolt through the height adjuster and

the license plate bracket and install washer and lock nut. Repeat

for other side of license plate bracket. Next install license plate to

upper and lower holes of the adjuster plates. (see diagram)

5. Attach the license plate to the bracket utilizing the (2)

screws, (6) washers, and (2) nuts. Tighten with the

4mm Allen wrench and 10mm wrench. The plate and

bracket may be bent slightly to allow the plate to sit

flat.

THANK YOU FOR USING THE ‘NO HOLES’ LICENSE PLATE BRACKET.