LD400+LD400P Instruction Manual Iss2
User Manual:
Open the PDF directly: View PDF
Page Count: 54
- LD400 Cover - Iss 2
- LD400 & LD400P Instruction Manual - Iss 2
- Français
- Deutsch
- Italiano
- Español
- Specification
- INPUT
- Maximum Input Ratings
- Input Terminals
- External Voltage Sense
- OPERATING MODES
- Constant Current Mode (CC)
- Constant Power Mode (CP)
- Constant Resistance Mode (CR)
- Constant Conductance Mode (CG)
- Constant Voltage Mode (CV)
- TRANSIENT CONTROL
- Transient Generator
- Slew Rate Control
- Oscillator Sync Output
- DROPOUT VOLTAGE
- Slow Start
- METER SPECIFICATIONS
- Measured Values
- CURRENT MONITOR OUTPUT
- REMOTE CONTROL
- Digital Remote Interfaces
- External Control Input Characteristics
- External Analogue Voltage Control
- External Logic Level (TTL) Control
- Remote Disable Input
- PROTECTION
- GENERAL
- Specification Notes
- EMC
- Safety
- Installation
- Connections
- Initial Operation
- Front Panel Operation
- Keys and Adjust
- The Display and the Home Screen
- General Numeric Entry of Parameters
- Variation of Parameter Values using Adjust
- Configuring the Load
- Selection of Load Mode
- Level A and Level B Setting and Range Selection
- Dropout Voltage
- Slow Start
- Introduction to Transient Operation
- Transient Menu
- Voltage and Current Limits
- Short Term or Intermittent Operation at up to 600 Watts
- Store and Recall Facilities
- Utilities Menu
- Analogue Remote Control
- Application Notes
- Remote Interface Configuration
- Status Reporting
- Input State and Input Trip Registers (ISR & ISE and ITR & ITE).
- Standard Event Status Registers (ESR and ESE)
- Execution Error Register (EER)
- Status Byte Register (STB) and GPIB Service Request Enable Register (SRE)
- GPIB Parallel Poll (PRE)
- Query Error Register - GPIB IEEE Std. 488.2 Error Handling
- Power on Settings
- LD400 Status Model
- Register Summary
- Remote Commands
- Maintenance
- LD400 Cover - Iss 2