Lab Five Lab05 Instructions
User Manual:
Open the PDF directly: View PDF 
.
Page Count: 2
EEC 417 / 517
−
Spring 2015 Lab Five Page 1 of 2
Lab 5
CCP PWM Mode, Program Memory Paging, Sleep Mode
This lab familiarizes the student with the pulse width modulation (PWM) feature of the CCP
module, program memory paging, stand-alone microcontroller operation, and sleep mode
(power-saving mode).
[ ] Create a new project that contains lab05.asm. This program uses the A/D input on AN0
to create a PWM signal on the RC2 output. Connect a pot to AN0 and an LED to RC2.
Run the program and turn the pot to make the LED dimmer or brighter.
[ ] Program your PIC so that it can run separately from the debugger. Here are some hints.
Note that we have been using the PICkit as a debugger by selecting the Debugger
→
Select Tool menu item. We can also use the PICkit as a programmer by selecting the
Programmer
→
Select Programmer menu item. You can use the PICkit as a debugger
or as a programmer, but not both at the same time. Also note that you can program the
PIC in either debug mode or stand-alone mode by selecting the Project
→
Build
Configuration menu item.
EEC 417 / 517
−
Spring 2015 Lab Five Page 2 of 2
