Quectel BC66 AT Commands Manual V1.0
User Manual:
Open the PDF directly: View PDF
Page Count: 93
- About the Document
- Contents
- Table Index
- 1 Introduction
- 2 Implementation Status
- 3 3GPP Commands (27.007)
- 3.1. ATI Display Product Identification Information
- 3.2. ATE Set Command Echo Mode
- 3.3. AT&W Store Current Parameters to User Defined Profile
- 3.4. AT+IPR Set TE-TA Fixed Local Rate
- 3.5. AT+CGMI Request Manufacturer Identification
- 3.6. AT+CGMM Request Model Identification
- 3.7. AT+CGMR Request Manufacturer Revision
- 3.8. AT+CSQ Signal Quality Report
- 3.9. AT+CESQ Extended Signal Quality
- 3.10. AT+CGSN Request Product Serial Number
- 3.11. AT+CPIN Enter PIN
- 3.12. AT+CEREG EPS Network Registration Status
- 3.13. AT+CSCON Signalling Connection Status
- 3.14. AT+COPS Operator Selection
- 3.15. AT+CGATT PS Attach or Detach
- 3.16. AT+CGDCONT Define a PDP Context
- 3.17. AT+CGACT PDP Context Activation/Deactivation
- 3.18. AT+CGPADDR Show PDP Addresses
- 3.19. AT+CIMI Request International Mobile Subscriber Identity
- 3.20. AT+CFUN Set UE Functionality
- 3.21. AT+CMEE Report Mobile Termination Error
- 3.22. AT+CCLK Return Current Date and Time
- 3.23. AT+CBC Query Power Supply Voltage
- 3.24. AT+CPSMS Power Saving Mode Setting
- 3.25. AT+CEDRXS eDRX Setting
- 3.26. AT+CEDRXRDP eDRX Read Dynamic Parameters
- 3.27. AT+CTZR Time Zone Reporting
- 3.28. AT+CIPCA Initial PDP Context Activation
- 3.29. AT+CCIOTOPT CloT Optimization Configuration
- 3.30. AT+CGAPNRC APN Rate Control
- 3.31. AT+CEER Extended Error Report
- 4 General Commands
- 4.1. AT+QGACT Activate/Deactivate a PDN Context
- 4.2. AT+QBAND Get and Set Mobile Operation Band
- 4.3. AT+QRST Automatically Reset
- 4.4. AT+QSPCHSC Set Scrambling Algorithm
- 4.5. AT+QLOCKF Lock NB-IoT Frequency
- 4.6. AT+QCSEARFCN Clear NB-IoT Stored EARFCN List
- 4.7. AT+QCGDEFCONT Set Default PSD Connection Settings
- 4.8. AT+QNBIOTRAI NB-IoT Release Assistance Indication
- 4.9. AT+QNBIOTEVENT Enable/Disable NB-IoT Related Event Report
- 4.10. AT+QATWAKEUP Enable/Disable Deep Sleep Wakeup Indication
- 4.11. AT+QENG Engineering Mode
- 4.12. AT+QCCID USIM Card Identification
- 4.13. AT+QPOWD Power off the Module
- 4.14. AT+QSCLK Configure Sleep Mode
- 5 Examples
- 6 Summary of <err> Codes
- 7 Appendix A Reference