Heater SCH4051 CN EN
User Manual: Heater SCH4051
Open the PDF directly: View PDF 
.
Page Count: 6
| Download | |
| Open PDF In Browser | View PDF |
TRUSTED FOR OVER 100 YEARS SCH4015 Series Sunbeam® Heater Instruction Leaflet PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS P L E A S E R E A D A N D S AV E T H E S E I M P O R TA N T S A F E T Y I N S T R U C T I O N S When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. Read all instructions before using this heater. 2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m) from the front of the heater and keep them away from the sides and rear. 3. Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended. 4. Always unplug heater when not in use. 5. Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Discard heater, or return to authorized service facility for examination and/or repair. 6. Do not use outdoors. 7. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container. 8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over. 9. To disconnect heater, turn controls to off, then remove plug from outlet. 10. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater. 11. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked. 12. A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored. 13. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. 14. Always plug heaters directly into a wall outlet/ receptacle. Never use with an extension cord or relocatable power tap (outlet/power strip). 15. When unplugging, be sure to pull by the plug and not the cord. 16. If the heater will not operate, see specific instructions on Auto Safety Shut-off. 17. DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void your warranty. The inside of the unit contains no user serviceable parts. All servicing should be performed by qualified personnel only. 18. Discontinue use if plug or outlet is hot. It is recommended that the outlet be replaced if plug or outlet is hot to touch. 19. The heater must not be located immediately below a socket-outlet. Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool. 20. CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility. 21. WARNING: In order to avoid overheating, do not cover the heater. 22. WARNING: This heater is not equipped with a device to control the room temperature. Do not use THIS APPLIANCE HAS A POLARIZED PLUG (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS SAFETY FEATURE IN ANY WAY. F E AT U R E S - O P E R AT I O N S this heater in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided. SAVE THESE INSTRUCTIONS TECHNICAL SPECIFICATIONS • Amps: 12.5 • Wattage: 1500W (+5% -10%) • Working voltage: 120V AC/60Hz OPERATING INSTRUCTIONS 1. Carefully remove your heater from the box. Please save the carton for off-season storage. 2. Make sure the unit is in the OFF ( 0 ) position before plugging the heater into the outlet. 3. Avoid overloading your circuit by not using other high wattage appliances in the same outlet. Place heater on a firm, level surface. At 1500 watts, this unit draws 12.5 Amps. Mode Control Turn the Mode Control to the desired setting: 0 - OFF Mode If you want to shut off the heater at any time of operation, turn the Mode Control to OFF ( 0 ) position. Power Light may remain lit until the heater is unplugged. - Fan only Setting Heater will run at fan-only operation without heat output. 1 - LOW Heat Thermostat Control 1. Before setting the thermostat, allow heater to operate and warm up the room. As noted, you need to turn the Thermostat Control clockwise to the highest position to start the heater. 2. When the desired temperature comfort level is reached, lower the thermostat setting until the power light turns off. This is done by moving the Thermostat Control counter-clockwise toward the lowest setting. 3. The control will now automatically maintain the pre-set temperature level by turning the heater ON and OFF. NOTE: It is normal for the heater to cycle ON and OFF as it maintains the preset temperature. To prevent the unit from cycling, you need to change the thermostat setting. CAUTION: FRONT GRILL IS HOT WHEN UNIT IS IN OPERATION. Figure 1 CONTROL PANEL CLOSE-UP A B C A. Thermostat Control B. Power Light C. Mode Control The heater will run continuously at 1000W. 2 - HIGH Heat The heater will run continuously at 1500W. NOTE: To start the heater operation, make sure the Thermostat Control is turned clockwise to the highest position. HCH 4051 heater 0/01 CLEANING/MAINTENANCE TROUBLESHOOTING CLEANING/MAINTENANCE TROUBLESHOOTING Always unplug the heater before cleaning and allow the heater to cool down. 1. Clean the unit with a soft cloth moistened with a mild soap solution. 2. NEVER use abrasive or flammable solvents to clean the unit. 3. After cleaning, be sure to completely dry the unit with a cloth or towel. 4. Store heater in a cool, dry location. If your heater fails to operate: • Turn the heater OFF and UNPLUG THE HEATER. • Make sure the electrical outlet or circuit breaker is working. • Check for obstructions. If you find an obstruction turn the heater OFF, and unplug the unit. Carefully remove the obstruction and follow the reset instructions. • The temperature may be set too low. Turn the Thermostat Control clockwise until the heater restarts. • Make sure Mode Control is in LO (1), HI (2) or FAN ( ) setting. Please DO NOT attempt to open or repair the heater. AUTO SAFETY SHUT-OFF This heater is equipped with a patented, technologically advanced, safety system that requires the user to reset the heater if there is a potential overheat situation. When a potential overheat temperature is reached, the system will automatically shut the heater off. It can only resume operation when the user resets the unit. RESET INSTRUCTIONS If your heater shuts down: 1) Turn Control to OFF. 2) Unplug the unit and wait 30 minutes. 3) Plug in and operate normally. If you have any questions regarding your product or would like to learn more about other Sunbeam® products, please contact our Consumer Service Department at 1-888-264-9669 or visit our website at www.sunbeam.ca. WA R R A N T Y I N F O R M AT I O N 1 YEAR LIMITED WARRANTY Sunbeam Products, Inc. doing business as Jarden Consumer Solutions or if in Canada, Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions (collectively “JCS”) warrants that for a period of one year from the date of purchase, this product will be free from defects in material and workmanship. JCS, at its option, will repair or replace this product or any component of the product found to be defective during the warranty period. Replacement will be made with a new or remanufactured product or component. If the product is no longer available, replacement may be made with a similar product of equal or greater value. This is your exclusive warranty. Do NOT attempt to repair or adjust any electrical or mechanical functions on this product. Doing so will void this warranty. This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable. Keep the original sales receipt. Proof of purchase is required to obtain warranty performance. JCS dealers, service centers, or retail stores selling JCS products do not have the right to alter, modify or any way change the terms and conditions of this warranty. This warranty does not cover normal wear of parts or damage resulting from any of the following: negligent use or misuse of the product, use on improper voltage or current, use contrary to the operating instructions, disassembly, repair or alteration by anyone other than JCS or an authorized JCS service center. Further, the warranty does not cover: Acts of God, such as fire, flood, hurricanes and tornadoes. What are the limits on JCS’s Liability? JCS shall not be liable for any incidental or consequential damages caused by the breach of any express, implied or statutory warranty or condition. Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for a particular purpose is limited in duration to the duration of the above warranty. JCS disclaims all other warranties, conditions or representations, express, implied, statutory or otherwise. JCS shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or inability to use the product including incidental, special, consequential or similar damages or loss of profits, or for any breach of contract, fundamental or otherwise, or for any claim brought against purchaser by any other party. Some provinces, states or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above limitations or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights that vary from province to province, state to state or jurisdiction to jurisdiction. How to Obtain Warranty Service In the U.S.A. If you have any questions regarding this warranty or would like to obtain warranty service, please call 1-888-264-9669 and a convenient service center address will be provided to you. In Canada If you have any questions regarding this warranty or would like to obtain warranty service, please call 1-888-264-9669 and a convenient service center address will be provided to you. WA R R A N T Y I N F O R M AT I O N In the U.S.A., this warranty is offered by Sunbeam Products, Inc. doing business as Jarden Consumer Solutions located in Boca Raton, Florida 33431. In Canada, this warranty is offered by Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions, located at 20 B Hereford Street, Brampton, Ontario L6Y 0M1. If you have any other problem or claim in connection with this product, please write our Consumer Service Department. PLEASE DO NOT RETURN THIS PRODUCT TO ANY OF THESE ADDRESSES OR TO THE PLACE OF PURCHASE. © 2014 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights reserved. Imported and distributed by Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions, 20B Hereford Street, Brampton, Ontario L6Y 0M1. Printed In China
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : Yes Tagged PDF : Yes XMP Toolkit : Adobe XMP Core 5.5-c014 79.151481, 2013/03/13-12:09:15 Create Date : 2014:07:02 22:34:35-04:00 Metadata Date : 2014:07:02 22:34:36-04:00 Modify Date : 2014:07:02 22:34:36-04:00 Creator Tool : Adobe InDesign CC (Macintosh) Instance ID : uuid:449114a4-849e-c746-b527-b865f6a2c7d0 Original Document ID : xmp.did:57172334-cf9c-475e-b43a-84e51a58dafa Document ID : xmp.id:a7f8a786-ee02-4210-bfd5-48b19f6e3049 Rendition Class : proof:pdf History Action : converted History Parameters : from application/x-indesign to application/pdf History Software Agent : Adobe InDesign CC (Macintosh) History Changed : / History When : 2014:07:02 22:34:35-04:00 Derived From Instance ID : xmp.iid:3bc6990e-b203-414c-acbe-1661e1441de0 Derived From Document ID : xmp.did:57172334-cf9c-475e-b43a-84e51a58dafa Derived From Original Document ID: xmp.did:57172334-cf9c-475e-b43a-84e51a58dafa Derived From Rendition Class : default Format : application/pdf Producer : Adobe PDF Library 10.0.1 Trapped : False Page Count : 6 Creator : Adobe InDesign CC (Macintosh)EXIF Metadata provided by EXIF.tools