Discovery Kit For STM32 F0 Series With STM32F072RB MCU STM32F07BDiscovery User Manual

• Figure 1. STM32F072 discovery board
• 1 Conventions
  • Table 1. ON/OFF conventions
• 2 Ordering and product information
• 3 Features
• 4 Hardware layout
  • Figure 2. Hardware block diagram
  • Figure 3. Top layout
  • Figure 4. Bottom layout
  • 4.1 Embedded ST-LINK/V2
    • Table 2. Jumper states
    • 4.1.1 Using ST-LINK/V2 to program/debug the STM32F072 on board
      • Figure 5. STM32F072 discovery board connections
    • 4.1.2 Using ST-LINK/V2 to program/debug an external STM32 application
      • Table 3. Debug connector CN2 (SWD)
      • Figure 6. ST-Link connections
  • 4.2 Power supply and power selection
  • 4.3 LEDs
  • 4.4 Pushbuttons
  • 4.5 Linear touch sensor / touch keys
  • 4.6 USB device support
  • 4.7 BOOT0 configuration
  • 4.8 Embedded USB Bootloader
  • 4.9 Gyroscope MEMS (ST MEMS L3GD20)
  • 4.10 JP2 (Idd)
  • 4.11 Extension and RF EEprom connector
    • Figure 7. Extension and RF EEprom connector
    • Table 4. Extension and RF EEprom connector (CN3)
  • 4.12 OSC clock
    • 4.12.1 OSC clock supply
    • 4.12.2 OSC 32 KHz clock supply
  • 4.13 Solder bridges
    • Table 5. Solder bridges
  • 4.14 Extension connectors
    • Table 6. MCU pin description versus board function
• 5 Mechanical drawing
  • Figure 8. STM32F072 discovery board mechanical drawing
• 6 Electrical schematics
  • Figure 9. STM32F072 discovery board
  • Figure 10. ST-LINK/V2 (SWD only)
  • Figure 11. STM32F072RBT6 MCU
  • Figure 12. MEMS and USB
  • Figure 13. Linear sensor and pushbutton
• 7 Revision history
  • Table 7. Document revision history