SCADAPack LP Hardware Manual Scada Pack

• Return to Index
• Overview
• Important Safety Information
• Installation
  • Field Wiring
• Power Supply
  • System Grounding
  • Power Management Features
    • COM3 Serial Port Power Control
    • VLOOP Power Control
      • VLOOP Over-Current Protection
    • 12V to 24V DC/DC Converter Control
• Analog Inputs
  • Internal Analog Inputs
  • I/O Analog Inputs
    • Analog Input Connections
    • Analog Input Wiring
    • Analog Input Wiring Examples
  • Analog Input Range Jumpers
  • Analog Inputs Data Format
• Analog Outputs
  • Current Outputs
  • Voltage Outputs
  • Analog Outputs Data Format
• Digital Outputs
• Digital Inputs
  • Digital I/O Connection Examples
• Counter Inputs
  • Counter Input 0
  • Turbine Meter Counter Inputs 1 and 2
• Serial Communication
  • RS-232 Serial Communications Ports
    • COM2 RS-232 Serial Port
    • COM3 RS-232 Serial Port
  • RS-232 Wiring Examples
    • DTE to DTE without Handshaking
    • DTE to DTE with Handshaking
    • DTE to DCE with Handshaking
  • RS-232 Cables
    • RJ-45 to DE-9S DTE
    • RJ-45 to SCADAPack Vision
    • RJ-45 to DE-9P DCE
  • COM1 RS-485 Serial Communication Port
    • RS-485 Bias Resistors
    • RS-485 Termination Resistors
  • RS-485 Wiring Examples
• Operation
  • Operating Modes
    • Run Mode
    • Service Mode
    • Cold Boot Mode
    • Sleep Mode
  • LED Indicators
  • LED Power Control
  • Jumpers
  • Status LED
    • I/O Module Error Indication
    • Register Assignment Checksum Error
• Maintenance
  • Fuses
  • Lithium Battery
    • Battery Replacement Procedure
• Troubleshooting
  • Analog Inputs
  • Analog Outputs
  • Digital Inputs
  • Digital Outputs
  • Counter Inputs
• Specifications
  • General
  • Controller
  • Communications
  • Visual Indicators
  • Power Supply
  • I/O Capacity
  • Analog Inputs
  • Analog Outputs
  • Counter Inputs
  • Digital Inputs/Outputs
• Approvals and Certifications