Lexmark E23x And E33x Service Manual E230 E232 E234 4505
User Manual: Service Manual La Biblioteca de los 8 bits
Open the PDF directly: View PDF
Page Count: 160 [warning: Documents this large are best viewed by clicking the View PDF Link!]
- Table of contents
- Laser notices
- Safety information
- Preface
- 1. General information
- 2. Diagnostic information
- Start
- Overview of the operator panel
- Operator panel codes
- Primary codes
- Ready / Power Saver
- Busy
- Hex Trace Ready
- Waiting
- Flushing / Resolution reduced
- Not ready
- Close door / Insert cartridge
- Load media
- Load manual feeder
- Print side two of duplex job
- Toner low
- Replace photoconductor kit
- Replace photoconductor kit (printer hard stop)
- Toner cartridge error / Toner cartridge is not installed
- Change invalid toner cartridge
- Invalid engine code / Invalid network code
- Programming engine code / Programming system code
- Cancel job / Reset printer
- Service error
- Printer error
- Secondary error codes
- Paper jam in the manual feeder
- Paper jams as it exits the tray into the printer
- Paper jams as a printed job exits the printer
- Complex page
- Insufficient printer memory
- Insufficient collation area
- Font error
- Defective flash
- Insufficient defrag memory
- Network interface errors
- Error communicating with host computer
- Memory full
- Short paper
- Flash full
- Unformatted flash
- Invalid engine code
- Invalid network code
- Primary codes
- Service information with secondary and tertiary light patterns
- Secondary error codes
- Tertiary service error codes
- Controller software
- Transfer roll
- Fuser, fan, or toner sensor error
- Codes 920 through 929 indicate a problem in the fuser (see “Fuser service check” on page253 for...
- Printhead, transport motor or RIP/engine communication error
- RIP to engine communication failure (controller card).
- NVRAM failure
- RAM memory error
- Network error
- Paper port communication failure
- Symptom tables
- Service checks
- Cold fuser service check
- Cooling fan service check
- Controller card service check
- Cover interlock switch service check
- Dead machine service check
- Fuser service check
- Hot fuser service check
- LVPS/HVPS service check
- Main motor service check
- Operator panel service check
- Printhead service check
- Paper feed service checks
- Parallel port service check
- Print quality service checks
- Using print quality test pages
- Transfer roll service check
- 3. Diagnostic aids
- 4. Repair information
- Removals
- Covers
- Fan removal
- Feed rollers (auto comp tires) removal
- Fuser idle gear links removal
- Fuser power cable removal
- Fuser removal
- Input roller clutch and lever removal (ACM clutch CBM)
- Input sensor #1 removal
- Input sensor #2 (manual) removal
- LVPS / HVPS card assembly removal
- LVPS / HVPS to controller card cable removal
- Manual feed clutch assembly removal
- Operator panel removal
- Paper exit guide assembly removal
- Printhead removal
- Toner level sensor cable removal
- Toner level sensor removal
- Transfer roll removal
- Transport motor cable removal
- Removals
- 5. Connector locations
- 6. Preventive maintenance
- 7. Parts catalog
- Index
- Part number index