Solar Wax Melter Manual
User Manual: manual pdf -FilePursuit
Open the PDF directly: View PDF 
.
Page Count: 5
AT
MICROFICHE
REFERENCE
LIBRARY
A project of Volunteers in Asia
.
and Uslno a Solar Wax Melts
Leaflet No. 2788
by: Robert Parsons
Published
by:
University of California
Division of Agricultural Sciences
1422 Harbour Way South
Richmond, CA 94804 USA
One copy will
be
sent free upon request.
Available from:
University of California
Division of Agricultural Sciences
1422 Harbour Way South
Richmond, CA 94804 USA
Reproduced by permission of the Division of
Agricultural Sciences, University of California.
Reproduction of this microfiche document in any
form is subject to the
same
restrictions as those
of the original document.
1
Making and Using
a
SOLAR WAX
.MELTER.
I
1
Division of Agri cultural Sciences
\~C~CY+V
/-LL> I
UNI
tW=
f!Al
Il=t?R
vLna3 1 tir
vr,LuI wn :NIA
I
s s.,,. , A NOVEMBER 1975
LIlYlMTFl
Construction Details
SOLAR WAX MELTER
wheel metal pan
318’ brace to hold lid up.
.%DE VIEW
I_-- rrv2---4
Wax Mekr has a double layer of l/2” cellotex,
except top rear, which has a
stngle
layer, and
front, which has no tnsulatton.
__---__----------
-_------__----__I
MAKING AND USING A SCLAR WAX MELTER
A
solar wax melter is a glass-covered box that uses the heat of tie sun to melt beeswax and
separate it from honey and other materials with which it is found in honey-bee colonies, The
nmlter can be used to render old conbs, cappings, burr con%, and other hive scrapings con-
taining wax. It is also handy for removing beeswax from excluders. The melter produces wax
of high quality and eliminates the need for the sometimes hazardous job of rendering wax in
the hame.
The sloping top surface of the solar wax nmlter provides maximum exposure to the sun and al-
laws honey and melted wax to drain quickly into the storage pan. Before use, the entire unit,
including the sheet-metal pan, should be painted black for maximum heat absorption. The glass
cover with two sheets of double-strength glass about one-fourth inch apart helps to retain
the absorbed heat. ‘Ihe cellotex, or fiberboard, insulation also serves the same purpose. In-
ternal temperatures well above the nmlting point of beeswax (about 145” F.) are maintained on
w-s SUNIY aavs= Place the Elter in a sunny, sheltered spot for best results.
The plan on the reverse side is meant to provide ideas on hm to build a melter. You need not
copy the plan exactly. For this reason, many dimensions are not given, especially the less
iqtortant ones. A melter of the size illustrated will handle all the wax from up to 60 hives
of bees. Modify the dimensions to fit your needs, or the materials available, but bedare of
making it too small. The sheet-metal pan should be 4 to 6 inches deep and big enough to ac-
cept excluders (16-l/4*’ x 20“) or at least two full-depth frames (19” x 20”). Consider the
possibility of making one or more cappings baskets of “expanded” metal that will fit into the
sheet-metal pan.
The pan to catch the hot honey and x&ted wax should be relatively large to prevent acciden-
tal overflaws. The one illustrated is an inexpensive plastic dish pan readily available in
many stores. The wax can be easily removed because it does not adhere well to the smooth,
flexible plastic. The sloping sides of the pan also make it easier to remove the cake of wax.
The wooden brace is designed to support the lid while you clean out the slumgum, or residue,
that remains after co&s are melted. It lies between the exterior box and the interior layer
of insulation. The finger hole, or notch, is used to pull it up into place. Cut the free
end at an angle so that it makes firm contact with the lid frame when the lid is a suitable
height to work beneath,
‘Ihe melted wax will flow more easily down the pan if the con&, excluders, and cappings bas-
kets are set on lengths of metal rods or angle iron. You may also want to put a coarse screen
across the outlet of the pan to keep unnmlted pieces of co& and other debris from flowing
into the pan of molten wax. The honey collects beneath the wax in the pan. It is darkened
and unsuitable for hunmn food,but can be used to feed bees in early spring (pzot in the fall).
The slumgum remaining in the sheet-metal pan contains beeswax ‘that can be removed only by a
hot water press. If you accuunilate 100 pounds or more, it is worthwhile having it rendered
commercially.
.’
, The lllelter is highly attractive to robber bees because of the odors given off by the warm
haney and wax. It should be kept tightly closed except when loading it or removing the
filled collecting pan.
l/ hxte - Apiculturist Department or H
orti ‘culture, University of Illinois at Urbana-
- ‘#. Chg;. -Material ‘reprinted by permission of author.
WoPEFfATlvE EXTENsloN
US DEPARTMENT OF AGRICUlTURE
UNIVERSITY OF CAUFORNIA
Berkeley, Colifornio 94720
OFFICIAL BUSINESS
Pcnolty for P&we ule SJDO
i
POSTAGE AND FEES PAID
U.S. DEPARTMENT OF
AGRICULTURE
AGR 101
THll?D CLASS
COOPERATIVE EXTENSION UNIVERSITY OF CALIFORNIA
This ~nfamatoon is provided bv C~operatwe Extenrion. an mhmat~onal agenw of Ihe University of California and the Uniled State6 Department of Agriculture. support for Cooperative
Exrcasion is wpplied by federal. state. and cotmn/ gonmmentr. Cooperative Exrenrion provider the people of California with rhe latest xientific mformsuon in agriculture and fmily
conswner sciences It ah spons(lcs rhe 4-H Youth Program. Cooperatwe Extenr~;n represenlaliver, serving 50 counties an Celdornia, a& known as farm, boms or youth advisors. whir
offices usually are located in the caunw rem. They wll be happy to provide you with information ir. their fields of work.
The University of California’s Cooperative Extension programs are available to all, without regard to race, color, or national origin.
Issued in furtherance of Cooperative Extension work, acts of May 8 and June 30, 1914, in cooperation with the United
Stotas Department of Agriculture. James 6. Kcndrick, Jr., Director, Cooperative Extension, University of California.
