DMM4040 And DMM4050 Digital Multimeter Programmer Tektronix Programming Manual
User Manual:
Open the PDF directly: View PDF
Page Count: 131 [warning: Documents this large are best viewed by clicking the View PDF Link!]
- DMM4040 and DMM4050 Programmer Manual
- Remote Operation
- Introduction
- Safety Information
- Optimizing System Speed for I/O Operation
- Selecting the Remote Interface Port
- Configuring the IEEE-488 Port
- Configuring the RS-232 Port
- Configuring the Ethernet (LAN) Port
- Establishing an Ethernet Connection
- Terminating an Ethernet Connection
- Selecting the Programming Language
- Getting Started With an Installation Test
- How the Meter Processes Input
- How the Meter Processes Output
- Triggering Input
- Service Requests (IEEE-488 Only) and Status Registers
- Supported SCPI Commands
- SCPI Command Summary
- SCPI Command Details
- Using the MEASure? Command
- Using the CONFigure Command
- Using the READ? Command
- Using the INITiate Command
- Using the FETCh? Command
- Using the SENSe Subsystem to Configure the Meter
- Programming for Math Operations
- Programming the Trigger System
- Using System-Related Commands
- Using Status Reporting Commands
- Calibration Commands
- Using RS-232/Ethernet Interface Commands
- Command Terminators
- Alternate Programming Language Compatibility
- FLUKE 45 Command Emulation Summary
- Using NI SignalExpress, Tektronix Edition
- FLUKE 8842A Emulation Mode
- Example Notes
- Device-Dependent Command Set
- Bn (Offset Commands)
- Dn (Display Commands)
- Fn (Function Commands)
- Get Commands
- G0 (Get Instrument Configuration)
- G1 (Get SRQ Mask)
- G3 (Get User-Defined Message)
- G4 (Get Calibration Status)
- G5 (Get IAB Status)
- G6 (Get YW Status)
- G7 (Get Error Status)
- G8 (Get Instrument Identification)
- N (Numeric Entry Command)
- Put Commands
- P0 (Put Instrument Configuration)
- P1 (Put SRQ Mask)
- Rn (Range Commands)
- Sn (Reading Rate Commands)
- Tn (Trigger Mode Commands)
- Wn (Terminator Commands)
- X0 (Clear Error Register Command)
- Yn (Suffix Commands)
- Z0 (Self-Test Command)
- Device Clear Command
- ? (Single-Trigger Command)
- Input Syntax
- Output Data
- Service Requests