Pakon F 235 Manual Alpha Revision 2.0 User F135
User Manual:
Open the PDF directly: View PDF
Page Count: 15
- F-135
- F-135 Plus
- User Manual
- Scanner Specifications
- Installing the F-135
- 1. Install the software for the F-135, if it is not already installed on the PC.
- 2. Clear a space near your computer system to place the F-135 scanner. The USB 2.0 cable must be able to reach the PC, so it cannot be more than 6 feet (2m) from the computer.
- 3. Connect the power cord to the power supply plug on the back of the scanner.
- 4. Connect the USB 2.0 cable to the back of the scanner.
- 5. Connect the USB 2.0 cable to the back of the computer, in a USB 2.0 port. Do not plug in to a USB 1.0 connector!
- 6. While the computer is on and Windows is loaded, turn the scanner power switch into the ‘on’ position.
- 7. Windows will prompt you to click “Next” to continue the driver installation.
- 8. Then click on “Finish” to finish the driver installation.
- 9. The process will repeat twice before finishing.
- 10. After the driver is finished installing, verify that the scanner driver is properly installed, by viewing the scanner properties in the Device Manager under the heading, “Imaging Devices.”
- 11. Clean the F-135 from any dust that may be inside the scanner. Please refer to these procedures in the “Operator Maintenance” chapter.
- BIOS Configuration
- Operational Information
- Operator Maintenance
- Service Policy
- Warranty
- Contacting Technical Support
- Regulatory Information