VisionSDK_UserGuide_TDA3xx Vision SDK User Guide TDA3xx

• TABLE OF CONTENTS
• 1 Introduction
  • 1.1 References
• 2 System Requirements
  • 2.1 Windows Installation
    • 2.1.1 PC Requirements
    • 2.1.2 Software Requirements
      • 2.1.2.1 A15 Compiler, Linker
    • 2.1.3 Code Composer Studio
  • 2.2 Linux Installation
    • 2.2.1 PC Requirements
    • 2.2.2 Software Requirements
      • 2.2.2.1 A15 Compiler, Linker
    • 2.2.3 Other software packages for build depending upon OS baseline
  • 2.3 Hardware Requirements
    • 2.3.1 Single Channel (SC) Use-case Hardware Setup
    • 2.3.2 VIP multi-channel LVDS capture (SRV) Use-case Hardware Setup
    • 2.3.3 ISS Multiple Channel (SRV) Use-case Hardware Setup
    • 2.3.4 Sensor Interfaces
    • 2.3.5 EDID Programming for HDMI Capture
  • 2.4 Required H/W modification / Configurations
    • 2.4.1 TDA3XX EVM Modifications for SCH use case
    • 2.4.2 Changes required on UB960 Application board
  • 2.5 Supported Sensors
  • 2.6 Software Installation
    • 2.6.1 Uninstall Procedure
• 3 Build and Run
  • 3.1 Overview of application in release
  • 3.2 Building the application
  • 3.3 UART settings
  • 3.4 Boot Modes
  • 3.5 Load using QSPI
    • 3.5.1 Steps to generate qspi writer tools
    • 3.5.2 Steps to generate appImage
    • 3.5.3 Flashing steps
  • 3.6 Load using QSPI and SD boot
    • 3.6.1 Steps to generate qspi writer tools
    • 3.6.2 Steps to generate appImage
    • 3.6.3 Flashing steps
  • 3.7 Load using CCS
  • 3.8 Run the demo
    • 3.8.1 Single channel demos with HDMI input
    • 3.8.2 Steps to run
  • 3.9 DCC
  • 3.10 Fast boot usecase
    • 3.10.1 Usecase configuration
    • 3.10.2 Hardware set up
    • 3.10.3 Build
    • 3.10.4 Generating and Flashing images
    • 3.10.5 Run
  • 3.11 Surround View Fast Boot Use case
  • 3.12 Surround View Use case under 128 MB DDR configuration
• 4 Revision History