XPS Q8 Programmer Manual
User Manual:
Open the PDF directly: View PDF
Page Count: 990 [warning: Documents this large are best viewed by clicking the View PDF Link!]
- Newport Website
- XPS-Q8 - Programmer’s Manual
- Preface
- Table of Contents
- 1.0 TCP/IP Communication
- Table of Contents
- 2.0 XPS Features
- 2.1 General Features
- 2.1.1 ControllerMotionKernelMinMaxTimeLoadGet
- 2.1.2 ControllerMotionKernelMinMaxTimeLoadReset
- 2.1.3 ControllerMotionKernelTimeLoadGet
- 2.1.4 ControllerRTTimeGet
- 2.1.5 ControllerSlaveStatusGet
- 2.1.6 ControllerSlaveStatusStringGet
- 2.1.7 ControllerStatusGet
- 2.1.8 ControllerStatusRead
- 2.1.9 ControllerStatusStringGet
- 2.1.10 ControllerSynchronizeCorrectorISR
- 2.1.11 DoubleGlobalArrayGet
- 2.1.12 DoubleGlobalArraySet
- 2.1.13 ErrorStringGet
- 2.1.14 ElapsedTimeGet
- 2.1.15 FirmwareVersionGet
- 2.1.16 GroupStatusStringGet
- 2.1.17 GlobalArrayGet
- 2.1.18 GlobalArraySet
- 2.1.19 InstallerVersionGet
- 2.1.20 KillAll
- 2.1.21 Reboot
- 2.1.22 RestartApplication
- 2.1.23 TimerGet
- 2.1.24 TimerSet
- 2.2 Positioner
- 2.3 Group
- 2.4 SingleAxis Group
- 2.5 SingleAxisWithClamping Group
- 2.6 SingleAxisTheta Group
- 2.7 Spindle Group
- 2.8 XY Group
- 2.9 XYZ Group
- 2.10 MultipleAxes Group
- 2.11 TZ Group
- 2.12 Analog and Nigital I/O
- 2.13 Gathering
- 2.14 Events and Actions
- 2.15 TCL Programming
- 2.16 Optional Module Programming
- 2.17 Hardware Date and Time Setting
- 2.18 Version
- 2.19 Positioner Error List
- 2.20 Positioner Hardware Status List
- 2.21 Positioner Driver Status List
- 2.22 Group Status List
- 2.23 Error List
- 2.24 Controller Status List
- 2.25 User Defined Soft Motor Output DAC Offsets
- 2.26 Gantry Configuration for MultipleAxes Group
- 2.27 Driver Notes for Precision Platform Firmware
- 2.28 Function List Classed in Categories
- 2.1 General Features
- 3.0 Process Examples
- Service Form
- Contact Us