AN972: EFR32 RF Evaluation Guide An972 Eval

• 1. Running Simplicity Studio
  • 1.1 Select RAILtest application
  • 1.2 Generate the Application
  • 1.3 Build the Application
  • 1.4 Load the Binary onto your Device/Flash Programming
  • 1.5 Serial Port Communication
  • 1.6 Console View
• 2. Basics of the RAILtest Application
  • 2.1 CLI
  • 2.2 Command Input
  • 2.3 Command Output
    • 2.3.1 Single Response
    • 2.3.2 Multi Response
• 3. Transmission Test
  • 3.1 Output a Continuous Unmodulated Tone for Testing Tx Power, Phase Noise and Spurious Emission
  • 3.2 Output a Continuous Modulated PN9 Stream for Testing Power Spectral Density Mask
  • 3.3 Enable Direct Mode
  • 3.4 Enable Packet Mode
• 4. Reception Test
  • 4.1 Running Bit Error Test from the CLI to Measure RX Sensitivity, Selectivity Testing (co, adjacent, alternate, image), Blocking, Intermodulation, Maximum Input Power
    • 4.1.1 BER Measurement Procedure
  • 4.2 Running a Packet Error Test from the CLI
    • 4.2.1 Basics of the Packet Error Rate
    • 4.2.2 Non-Triggered PER
    • 4.2.3 Triggered PER
  • 4.3 RSSI Curve
    • 4.3.1 Customer Production Test: Transmission Power
• 5. Current Consumption Test